Klegg electronic manual M6 501P Operation Pro Logic Mode, O L O G L L P C M, O L O G N a B L E

M6 501P Operation – Pro Logic Mode

Pro Logic Mode

power

mute

balance delay prologic

field		EQ on/off	EQ setup
preset	1	preset 2	preset 3

Your M6 501P will automatically switch to Pro Logic mode when it detects the Pro Logic signal. With other signal inputs you can select the Dolby Pro Logic mode by pressing Prologic Button on the remote. Repeatedly pressing the Prologic Button will cycle the Pro Logic mode in the order of: “AUTO”, “ALL PCM”, “ENABLE” and “DISABLE ”.

If a Pro Logic signal is detected the M6 501P will switch to Pro Logic mode automatically and

the following information is displayed:

D o l b y D i g i t a I C o

P R O L O G I C A耟 U T O

If a Stereo signal (either in analog or in digital form) is detected the M6 501P will switch to

Stereo mode automatically. You can then convert the stereo signal to Pro Logic mode by

pressing thePrologic Button until the display reads as follows:

D	o	l	b y	D i		g i t	a	I	C o
P R O L O G I					C A L L P C M
					or
D	o	l	b y	D i		g i t a		I	C o
P R O L O G I					C E N A B L E

In the case of converting a Pro Logic or 2-channel Dolby Digital signal into Stereo mode, press

the Prologic Button until the display reads as follows:

D o l b y D i g i t a I C o

P R O L O G I C D I S A B L E

22