B&B Electronics 2011 manual Installation, Connecting the Asynchronous Port

Page 7

4.0 INSTALLATION

The Model 2011 is designed to be used in pairs, with one unit installed between an asynchronous DTE and a synchronous DCE on either end of a synchronous communication link. Figure 3 illustrates a typical Model 2011 installation.

Figure 3. Typical Model 2011 application

4.1 CONNECTING THE ASYNCHRONOUS PORT

The asynchronous port of the Model 2011 is a DB-25 female and is configured as "DCE". Therefore it wants to talk to a DTE device such as a terminal or PC. The Model 2011 may be plugged directly into the DB-25 serial port of a DTE or connected via "straight through" cable.

4.2 CONNECTING THE SYNCHRONOUS PORT

The synchronous port of the Model 2011 is a DB-25 male and is configured as "DTE". Therefore it wants to talk to a DCE device such as a modem or multiplexer. The Model 2011 may be plugged directly into the DB-25 serial port of a DCE or connected via "straight through" cable.

2011AS3297 Manual

5

B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350

PH (815) 433-5100 -- FAX (815) 434-7094

Page 6 Page 8
Image 7
Page 6 Page 8
Contents High Speed Asynchronous to Synchronous Converter Table of Contents Service Warranty InformationRadio and TV Interference General Information FeaturesDescription Accessing Internal Switches ConfigurationSetting Internal Switches Character Length Connecting the Asynchronous Port InstallationConnecting the Synchronous Port Data Transmission Full or half duplex Appendix a SpecificationsAppendix B Asynchronous Port Connections Configured AS DCE Appendix C Synchronous Port Connections Configured AS DTE Appendix D Block Diagram
Top Page Image Contents