B&B Electronics 232SPS2 manual Table B-3, Table B-4

Some printers may require one or more of the following connections:

6.Data Set Ready (DSR) from the printer must be connected to Pin #6 on the 232SPS2 module.

7.Clear To Send (CTS) from the printer should be connected to Pin #5 on the 232SPS2 module.

8.Data Carrier Detect (DCD) from the printer should be connected to Pin #8 on the 232SPS2 module.

NOTE: IBM PC’s (or compatible) serial ports and serial printers are both DTE devices. Therefore, a null modem cable (like a serial printer cable!) must be used when connecting a PC’s serial port to a printer. A null modem cable or serial printer cable should not be used to connect to the 232SPS2 (unless your device is a DCE -- such as a modem).

TABLE B-3

DB-25 Serial Port Connections (P to S)

Serial Port			232SPS2
(DTE)			(DCE)
	Signal Name	Direction	DB-25P
DB-25S
			Pin #
2	Transmit Data	----------->	2
3	Receive Data	<-----------	3
4	Request to Send		4
5	Clear to Send	<-----------	5**
6	Data Set Ready	<-----------	6**
7	Signal Ground		7
8	Carrier Detect	<-----------	8**
20	Data Terminal	----------->	20
	Ready
22	Ring Indicator		22

TABLE B-4

DB-9 Serial Port Connections (P to S)

Serial Port			232SPS2
(DTE)			(DCE)
DB-9S	Signal Name	Direction	DB-25P
Pin #			Pin #
1	Data Carrier Detect	<-----------	8**
2	Receive Data	<-----------	3
3	Transmit Data	----------->	2
4	Data Terminal	----------->	20
	Ready
5	Signal Ground		7
6	Data Set Ready	<-----------	6**
7	Request to Send		4
8	Clear to Send	<-----------	5**

*When using XON/XOFF control, this connection may not be required.

**Some printers may require this connection.

232SPS2-3903 Manual	Appendix B: Serial Port Connections	B-5	B-6	Appendix B: Serial Port Connections	232SPS2-3903 Manual
B&B Electronics --	PO Box 1040 -- Ottawa, IL 61350			B&B Electronics -- PO Box 1040 --	Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104				PH (815) 433-5100 -- FAX (815) 433-5104