1. OPERATING INSTRUCTIONS
1-1. FRONT PANEL CONTROLS
1. Monitor Selector Switch (VIDEO A/B)
Turn this Monitor selector switch A position for a signal fed through the rear panel VIDEO A connectors.
Then, turn this Monitor selector switch B posi- tion for a signal fed through the rear panel VIDEO B connectors.
2. Contrast Control (
CONTRAST)
Turn to adjust picture contrast according to your requirement.
3. Brightness Control (
BIRGHT)
Turn to adjust picture brightness according to your requirement.
4. Power Indicator
Lights when the power is on.
Lit: When the power is on.
Unlit: When the power is off.
5. Power Switch (POWER)
Press this switch to turn the power on or off.
12 3 4 5
Fig. 3
1-2. REAR PANEL CONTROLS & CONNECTION
1. AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely to this socket and to a wall outlet.
However, the last monitor termination switch should be the 75 ohm position for proper line termination.
2. Video input terminals (VIDEO IN)
These terminals are used to input a video signal source to this monitor.
Connect to the video output of a VCR or an- other monitor (for loop through connection) or to a video camera.
3.Video output terminals (VIDEO OUT)
These terminals are used to output a video signal for this monitor.
4.Termination Switch (HI/75 Ω (Lo))
Select the input impedance (HI/75 ohm). When using only one monitor, turn the termina- tion switch to the 75 ohm position. When using more than one monitor, set all of the termination switch to the monitors to the HI position.
6.
Turn to adjust picture brightness.
7.Vertical Size control
Turn to adjust picture vertical size of the picture.
8. Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the screen, turn this control until there is a single steady picture.
I
– 5 – | i n d ex |