REMOTE CONTROL MODEL MBR3430
PREPARATION FOR USE
Batteries are provided with this remote, but you must install them before using the remote.
INSTALLING BATTERIES
When the effective operating range of your remote becomes noticeably shorter, replace the batteries with two
Zenith is not responsible for damage caused by battery leakage.
After installing new batteries, the remote control will set itself to Zenith brand codes, as follows: TV=1 0 I, VCR=20 1 and CABLE=30 1.
If you are going to operate equipment that uses different codes, the remote must be reprogrammed for those codes.
AUTO FIND MODE
Use Auto Find to automatically find the brand code needed to operate your equipment L)
NOTE: If no button is pressed for 60 seconds or more during Auto Find, the remote will automatically exit Auto Find without storing any brand codes. (LEDs will flash 3 times upon exiting.)
1.Turn on the equipment you wish the remote to oper- ate.
2.Press and hold LEARN until mode indicator lights (about 4 seconds).
3.Use MODE to select the mode you wish to program (TV, VCR or CABLE).
4.Enter “00” then press ENTER within 2 seconds. All four mode indicator lights will turn ON and then OFF, leaving the mode indicator light for the active mode ON.
5.Point remote towards the equipment.
6.Press and release OFF/ON on the remote about once every second, until the equipment turns OFF. Press ENTER before pressing any other buttons.
If you press OFF/ON again before pressing ENTER Auto Find will have to be repeated.
7.Try other buttons to see if they operate the equipment. If they do not, you may wish to reenter Auto Find and try to find another code. The remote will begin with codes starting from where it left off prior to exiting Auto Find.
_ |
|
| // | |
CHANNEL | , | |||
g(g |
| |||
|
|
|
| |
| I | |||
|
|
|
|
|
|
| i | ||
8.Repeat Auto Find for each piece of equipment you want your remote to operate. NOTE: Only one brand code can be programmed in each of the four modes.
If no brand code has been entered after searching through all brand codes in any mode, the remote will flash all four mode indicator lights in a chasing manner. Wait 60 seconds or press ENTER or LEARN to return to normal operation.
4 - 5 |