Setting UP Your Remote Control

15-1916b.fm Page 6 Monday, July 19, 1999 12:17 PM

Note: Do not place objects on top of the remote control after you install the batteries. This can press down keys and reduce battery life.

1.Refer to “Manufacturers’ Codes” on Page 10 and write down the codes for your original remote controls on the provided label.

2.Press the device key for the type of remote you are replacing (TV, VCR, or CBL).

3.Hold down P until the red indicator blinks twice, then release P and enter the 3-digit manufacturer’s code.

For example, to replace a Panasonic TV’s remote control (manufacturer code 051), you would press:

TV P 0 5 1

4.When the indicator blinks twice again, point the 3 in 1 at your device and press PWR. The device should turn on (or off, if it was on).

Repeat these steps for additional devices.

Notes:

•The punch-through feature is automatically turned on for the TV’s volume and mute con- trols. This means that when you select CBL and press one of the volume buttons or MUTE, the remote actually sends the codes to the television to control it, not the cable converter. If you want to use your cable con- verter’s volume and mute controls, disable the punch-through feature for these buttons. See “Punch Through” on Page 8.

Need help? Call 1-800-955-2599