QUICK INSTALLATION
Before turning on your television set for the first time, be sure to place it on a solid stable surface. To avoid danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct the ventilation grid at the rear and be sure to leave sufficient gaps around the unit as shown.
2 3/8"
2 | 3/8" |
| 7 | 7/8" |
1.Connect a TV antenna or a CATV cable to the Antenna Terminal on rear of TV.
2.Connect the power cord.
3.Press the 
/ ON button to turn on the unit.
4.Press the 
or 
button to select “Yes” or “No”, then press the ENTER button to confirm.
5.The unit will enter TV setting screen. Press the 
button to highlight Auto Scan, then press the ENTER button to confirm.
6.The unit will enter auto scan setting screen. Press the 
button to highlight Cable System, then press the 
or 
button to choose the desired cable system (We recommend you pick “AUTO”, however you might find you get improved results using “STD”, “IRC” or “HRC” - these are different standards used by various Cable Systems.). Then use the 
button to move the highlight bar on Start to Scan and press ENTER button to start. The unit will take a few minutes to finish auto scan and all scanned channels will be stored automatically.
Picture | Audio | Time | Setup | Parental | TV |
|
|
|
|
|
| ||
Cable System |
| AUTO |
|
| ||
Start to Scan |
|
|
|
|
| |
|
|
|
|
|
|
|
Select | Adjust | MENU Return |
Proceed with auto scan? |
| ||
No |
| Yes |
|
: SELECT | "ENTER": CONFIRM |
| |
Picture Audio | Time | Setup Parental | TV |
Antenna |
| Cable |
|
Auto Scan |
|
|
|
Auto Scan Add CH |
|
|
|
Channel Skip |
|
|
|
Channel No. |
|
|
|
Channel Label |
|
|
|
DTV Signal | : |
|
|
| Select |
|
| Adjust | MENU | Return |
Picture | Audio | Time |
| Setup | Parental | TV |
|
| RF CH | : |
| 3 |
|
|
| Found | : |
| 0 |
|
| Select |
|
| Adjust | MENU | Return |
Turning On the Unit for the first time
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the screen to complete basic TV settings.
Make sure the TV antenna or CATV cable has been connected properly to the TV antenna input jack on the rear of the system.
E - 3