Venturer PLV36199S1 manual Quick Installation, Turning On the Unit for the first time

QUICK INSTALLATION

When you turn on your television set for the first	2 3/8"
time, be sure to place it on a solid stable surface.
To avoid danger, do not expose the TV to water,
or a heat source (e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid at the rear
and be sure to leave sufficient gaps around the	2 3/8"
unit as shown.

2 3/8"

Turning On the Unit for the first time

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on the screen to complete basic TV settings.

Make sure the RF aerial has been connected properly to the TV antenna input jack on the rear

of the system.

Proceed with auto scan ?

NoYes

:SELECT "ENTER":CONFIRM

PICTURE AUDIO	TIME	SETUP PARENTAL TV
Antenna		CATV
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal
UP/DOWN	ADJUST "MENU":EXIT

1.Press the / button to select Yes. Press the ENTER button to proceed with the initial setup.

PICTURE AUDIO	TIME	SETUP PARENTAL TV
Cable System		AUTO
Start to Scan

UP/DOWN ADJUST "MENU":EXIT

2.Use the / button to select Antenna, then press the / button to select Air or CATV.

PICTURE AUDIO		TIME	SETUP	PARENTAL TV
	RF CH		:	16
	Found		:	0

PRESS <MENU> TO EXIT AUTO SCAN

3.Use the / button to select Auto Scan, then press the button to enter auto scan menu. Use the / button to select Start to Scan, press the button to begin scanning. (If you selected CATV on Step 2, you need to select Cable System before Start to Scan). The system will automatically start to scan and preset all available TV channels.

4.After scanning has finished the system will return to the first TV channel scanned.

E - 3

PLV36199.indd 3

8/28/2007 3:15:06 PM