Winegard SK-3005 Recommended Receivers, Selecting a Location for the TRAV’LER Antenna

Page 2

Congratulations!

You have selected the Winegard® TRAV’LER Automatic Multi-Satellite TV Antenna. The TRAV’LER antenna will deliver the ability to view up to five satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy to use functionality

just like you get at home. This manual provides important information on the installation and operation of your TRAV’LER Interface Box. Please take time to read the manual in it’s entirety before installing or operating your antenna.

Icons appearing in the manual are used for important information and helpful tips. Alert indicates important information regarding

product use, product specifications or procedures.

Important tip offers helpful suggestions or refers you to a related topic in the manual.

Recommended Receivers:

The Winegard® TRAV’LER Automatic Multi-Satellite TV Antenna will work with any DIRECTV® receiver currently in production. Consult your receiver manual or www.winegard.com if you have any questions about whether your receiver is compatible. However, we recommend:

DIRECTV : models D11 and H20

Each receiver will require at least one coax cable. Refer to receiver manual for wiring details.

Check with your programming provider for coverage in certain areas.

Before you begin, please make sure you have received all necessary parts to properly install and oper- ate your TRAV’LER antenna.

-Installation/Operation Manual

-Mount Base with 30’ Cable - Power/Control Cable

-TRAV’LER Interface Box

-Reflector, LNBF & Feed Arm

-24” AC power cord

-TRAV’LER Power supply

-Gray Coax Cable 30’

-Black Coax Cable 30’

-Mounting Hardware bag

-Cable Entry Hardware bag

Selecting a Location for the TRAV’LER Antenna

Before removing the TRAV’LER antenna from its box, check with your RV Dealer or manufacturer. Your RV may be pre-wired or have a reinforced area for this system. DO NOT install in a location where a gap of 3/16” or more exists, as it may damage the roof. See diagram at top of page 3.

When installing the TRAV’LER on a rubber roof, Winegard recommends using the SKA-004 Roller Plate. If not using this plate, make sure that the roller does not come in contact with any rib supports or bubbles in the roof when in operation. Failure to do so, may result in damage to the roof.

INSTALLATION

2

Image 2
Contents Winegard Recommended Receivers Selecting a Location for the TRAV’LER AntennaTransition Plate TRAV’LER Mount Installation Make sure to clean the installation area before you beginCable Entry Plate Installation You will need to runAutomatic Cable installationReflector Installation Raise AntennaPress Enter Receiver Setup Pinch Point Pinch PointsMaking the Right Connection with Hex Connectors AppendixSatellite Receiver Warranty Installation Winegard Company 3000 Kirkwood St. Burlington, IA
Related manuals
Manual 10 pages 31.38 Kb