Receiver Setup, Emergency Power Off, Other Notes

Receiver Setup, Continued

9	The program	10
	guide will

download.

When the status bar reaches 100%, press Continue.

11	You will be	12
	prompted to set

up the remote. Select Setup Remote Later to do this at a later time.

The receiver will run Data Feed and Guide Feed Tests for a few moments.

Select

Watch DIRECTV.

You are now ready to watch TV!

Emergency Power Off

The Winegard TRAV’LER antenna comes with an Emergency Power Off feature. To activate it, press and hold [POWER] and then press [SELECT] while still holding [POWER]. The TRAV’LER antenna will stop and turn off.

If the Emergency Power Off feature is used, the TRAV’LER antenna may not be in a safe position for travel.

Do not move the vehicle until you are able to stow the unit. See Ready to Travel? above.

Other Notes

Weather and vehicle location can impact the ability of the TRAV’LER antenna to locate all of the required satellites. Obstructions such as buildings or tree limbs can block the satellite signals and prevent the TRAV’LER antenna from successfully locating all of the satellites for Multi-Sat Mode. Make sure you have a clear view of the southern sky.

Receivers Compatible with SWM Technology

Winegard mobile satellite TV antennas operate with Multi-switch technology and require separate accessories to operate with DIRECTV Single Wire Multi-switch (SWM) only technology receivers.

For an up-to-date list of DIRECTV DVR and non-DVR receiver models that are only compatible with SWM technology, visit www.winegard.com/directv. This website also lists Winegard mobile satellite TV antennas that are compatible with DIRECTV.

If unsure of your receiver model, check the back of the receiver or the inside front door of the smart card slot.

Model Number

Ready to Travel?

The TRAV’LER antenna is not meant for use while traveling.

To stow the unit when you are ready to travel, press [POWER] one time.	Stowed/Travel Position

The unit will stop what it is doing and return to the stowed position.
The TRAV’LER interface will not turn off unless the TRAV’LER mount is
successfully stowed. Visually inspect that the antenna is in the stowed/
travel position before traveling.
Do not move the vehicle until the TRAV’LER antenna is stowed.

Emergency Manual Stow

Emergency manual stow is meant as a last resort and is not meant for common usage!

Unplug the TRAV’LER interface. Then, remove the black plastic bolt from the back of the mount. Insert a 3/8th socket extension into this auxiliary drive. Turn the auxiliary drive clockwise to lower the unit. Do not use a drill!

If you have a SWM only technology receiver, Winegard Model SWM-840 SWM kit is available. This SWM kit will allow for proper SWM technology operation with Winegard mobile satellite TV antennas.

www.winegard.com

Technical Services, call 1-800-788-4417.

For Receivers, call 1-866-609-9374.

For up-to-date information on receiver compatibility and programming,

visit www.winegard.com/receivers.

Operation