Winegard RTS-80B Parts Included, Tools Needed for Unpacking & Installation, Unpacking the Unit

Page 2

Parts Included • Tools Needed • Unpacking the Unit

PARTS INCLUDED*:

1 Dome

1 base with electronics, dish, dual LNBF

*Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation

TOOLS NEEDED FOR UNPACKING & INSTALLATION:

Level

Drill with 3/4” bit

1-1/4” hole saw (if mounting switch in wall) Phillips screw driver #2

UNPACKING THE UNIT:

1. Open box and remove packing material.

If using knife to open ! carton, BE CAREFUL.

Do not cut the dome on the unit.

For Winegard Warranty Information:

Attn: Technical Services Winegard Company 3111 Kirkwood St. Burlington, IA 52601 800-788-4417

Fax: 319-758-5854

3/8” Open end wrench 7/16” Open end wrench

Sealant (consult RV manufacturer for proper type for your roof material)

2.Lift unit out of box vertically. Do not turn box and “roll” out, or turn upside down to remove.

USE 2 PEOPLE

when removing the unit from the carton.

DO NOT PAINT DOME! ! Painting dome will cause

signal degradation and will void your warranty.

Disclaimer:

Although every effort has been made to insure the information in this manual is correct and complete, no company shall be held liable for any errors or omissions in this manual. Changes and technological advances are continu- ously being made in the satellite market. Information provided in this manual was accurate at the time of printing. If the RoadTrip Minimax does not function as expected, please contact Winegard Company at (800) 788-4417 or visit our website at www.winegard.com.

Trademarks:

Winegard and RoadTrip Minimax are registered trademarks of Winegard Company. DISH Network is a registered trademark of EchoStar Communications Corp. DIRECTV is a registered trademark of Hughes Electronics Corp. All trademarks contained in this manual are property of their respective owners. Reference made to products or services provided by companies, other than Winegard Company, does not represent any endorsement of those products or services.

2

Image 2
Contents Winegard Made in the U.S.AParts Included Tools Needed for Unpacking & InstallationFor Winegard Warranty Information Unpacking the UnitFront of Vehicle Directv Dish Network Bell TV KEYDish Network Hybrid Cable entry installation Connecting ONE receiver Installing the Power SwitchConnecting Receivers Connecting TWO receiversBasic RoadTrip Minimax Antenna Wiring Directv programmingPage Troubleshooting Problem SolutionDish Network Programming Dish Network Eastern ARC Directv Programming Specifications & Warranty Features and specifications