Winegard rm-4610 owner manual Approximately From Travel Position, Directional Handle, Point to

Page 10

CAUTION: After INITIAL	FIGURE 15
INSTALLATION, the
antenna should ROTATE
APPROXIMATELY 360°
FROM TRAVEL POSITION.
The pointer on the
DIRECTIONAL HANDLE
should point towards the
RED SCREW on the
ROTATION CLAMP when
in TRAVEL POSITION.

ASSEMBLED VIEW

POINTER		Rotation
POINTER		Clamp
MUST POINT		Clamp
MUST POINT		Red Screw
TO RED		Red Screw
TO RED
SCREW ON
ROTATION
CLAMP		Flat Washer
WHEN IN
TRAVEL	POINT TO
POSITION	BACK OF RV	Nut for
	BACK OF RV	Nut for
		threaded tube

CAUTION:

The antenna MUST BE IN THE

TRAVEL POSITION before

ALIGNING the Directional

Handle and Ceiling Plate.

Tighten screw snugly

Elevating Shaft

Threaded Tube

3 Directional Handle Extension

1 Ceiling Plate

2(4) #10 Phillips Flat Head Screws

4Directional Handle

ALIGN POINTER

WITH ANTENNA

TRAVEL POSITION

5ELEVATING CRANK HANDLE (When installed, extends 2-1/4" from ceiling). Snap Handle into base when not in use.

10

Image 10

Contents Winegard Parts Included Reflector dish GasketFinding the Satellite TroubleshootingTuning Antenna for the Best Picture OperationDO’S Suggested Setups for Multiple TVSOperations DO’S and DON’T’S DON’T’STrouble Shooting Installation and Assembly Things YOU NeedCable-entry plate Minimum 3 from mount base Mount travel bracket to roof 6-1/8 from base, , Inside Your RV For RM-DM61/RM-DM55 onlyDigital Elevation Sensor Roof Connections Cutting Shaft If YOU are Using AN Exten³ Figure LENGTH, aDirectional Handle Approximately From Travel PositionPoint to Parts View Hardware KIT Parts ListInterior RK-CEILSpecifications ANTENNA/LIFT/LNBF TWO Year Limited WarrantyReplacement Parts Kits