
Operation Instructions for Motorized Sensar
FIGURE 1
Controller
Panel
Turn Power
On/Off
Rotate
Antenna
Clockwise
Raise/Stow |
Antenna |
Indicates Antenna |
is fully raised |
Indicates Antenna |
is moving |
Indicates Antenna is |
in Travel Position |
Rotate Antenna |
Counter Clockwise |
NOTE: Blinking lights indicate obstruction.
Control Panel Light and Button Functions:
(All three lights blink when obstruction occurs - See Trouble Shooting)
Figure1showscontrolpanelcomponents.Operationissimply a matter of pressing the button for the operation you desire.
OPERATION
STEP 1: Press Power Button, light by button will come on. One of the three middle lights will also turn on showing antenna position.
STEP 2: Turn on power supply to antenna.
STEP 3: Press Raise/Stow Button. Motion light will turn on and antenna will raise. When antenna has raised, the motion light will turn off and the raised light will be on.
STEP 4: Press ROTATE counter clockwise button to rotate unit towards signal. Motion light will turn on. You must hold this button in to maintain rotation. View your TV Picture and release button to stop antenna rotation when TV picture appears to be the best quality for your location. NOTE: If pressing button does not turn on Motion light, the antenna is at
it's maximum rotation or not in up position.
STEP 5: To view a different TV channel, switch TV to channel you desire and press and hold either rotate button until your TV picture appears to be the best quality for your location.
To Stow Antenna:
STEP 6: Push RAISE/STOW button to stow antenna. MOTION LED will be lit. The antenna will automatically return to its home position before stowing. MOTION LED will turn off. STOWED LED will turn on.
STEP 7: Push POWER Button on control panel and ON/ OFF button on wall plate power supply to turn antenna off.
NOTE: BEFORE MOVING RV, ANTENNA MUST BE IN STOWED POSITION. VISIBLY CONFIRM ANTENNA IS DOWN BEFORE MOVING.
2