Tripp Lite DWT1323S owner manual 2b. Mount on Solid Brick and Concrete Block

Page 5

2b. Mount on Solid Brick and Concrete Block

1

Mark the exact location of mounting holes

2

Concrete Anchor

Drill pilot holes

Anchor Bolt

5mm-8mm

Screw the wall mount onto the wall

Tighten the screw spacing 5mm-8mm to wall plate.

WARNING

•When installing wall mounts on cinder block, verify the actual concrete thickness is at least 1-3/8” (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1” (25mm) minimum from the side of the block. It is suggested an electric drill on a slow setting be used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

5

13-09-229-93-32A5-EN.indd 5

10/31/2013 9:59:06 AM

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Tilt Flat Screen Warranty Registration Warranty & Warranty RegistrationComponent Checklist 2a. Mount on Wood Stud Wall Disassemble Vesa Plate2b. Mount on Solid Brick and Concrete Block For clarity, outer cover is not shown Install the Wall PlateInstall the Vesa Plate Hang the display onto the Wall Plate Adjustment
Top Page Image Contents