Palsonic 8110 owner manual Channel selection, To watch a TV programme

To select a two-digit position number (10~99)

METHOD 1: Press these two numbers and the screen displays "XX -", (The period of two-press must be within 2 seconds). Wait for 2 seconds and the channel is selected.

METHOD 2: Press 0 button first, than press these two numbers, the screen displays "0XX", the channel is selected. (The period of two-press must be within 2 seconds).

To select a three-digit position number (100~255)

Press these three numbers and the screen displays "XXX" the channel is selected. (The period of two-press must be within 2 seconds).

NOTE: If the input number is over 255, the screen will remain at the current viewed program.

Using the CH buttons

Press CH to select lower position numbers;

CH to select higher ones.

Using the PREVIOUS channel button ()

When there are no menus on the screen, pressing the button on the remote controller (below the MENU button) can swap the current viewed channel with the previous one. For example, the channel you previously watched is 11, the present channel is 2, press the button, it will return to channel 11, press the button again it will return to channel 2.

Using the channel SCAN button

X--

XX-

XX

X--

XX-

XXX

3

2

1

11

2