Palsonic 6160G owner manual Channel selection, To watch a TV programme

Page 14

OPERATION

Channel selection

You can watch TV programmes being broadcast on the preset channels.

To watch a TV programme

You can select your desired TV program by one of the following methods.

Using the direct select buttons

To select a one-digit position number (0~9)

 

 

 

 

 

 

 

 

METHOD 1: Press the button and the screen displays "X- -", wait for 2

 

After 2

 

X--

seconds and the channel is selected.

 

seconds

 

 

 

 

 

 

 

 

METHOD 2: Press 0 button and the screen displays "0- -", then press 0 button

 

 

 

X

 

 

 

again, the screen displays "00-" then press the numbers. (The

 

 

 

 

 

 

 

period of two-press must be within 2 seconds).

 

 

 

 

To select a two-digit position number (10~99)

METHOD 1: Press these two numbers and the screen displays "XX -", (The period of two-press must be within 2 seconds). Wait for 2 seconds and the channel is selected.

METHOD 2: Press 0 button first, than press these two numbers, the screen displays "0XX", the channel is selected. (The period of two-press must be within 2 seconds).

To select a three-digit position number (100~255)

Press these three numbers and the screen displays "XXX" the channel is selected. (The period of two-press must be within 2 seconds).

NOTE: If the input number is over 255, the screen will remain at the current viewed program.

Using the CH buttons

Press CH to select lower position numbers;

CH to select higher ones.

Using the PREVIOUS channel button ()

When there are no menus on the screen, pressing the button on the remote controller (below the MENU button) can swap the current viewed channel with the previous one. For example, the channel you previously watched is 11, the present channel is 2, press the button, it will return to channel 11, press the button again it will return to channel 2.

Using the channel SCAN button

X--

XX-

XX

X--

XX-

XXX

3

2

1

11

2

Press SCAN button, the set will scan the channels from first channel to higher channels one by one, every program will be displayed for about 3 seconds and then go on scanning until all programs are scanned over and then return to your former viewed program. During the scanning, press SCAN button again, the set will return to your former viewed program.

12

Image 14
Contents 61CM Cordless Remote Colour Television Contents Introduction Page Antenna Connection Battery installationEffective range of the remote control operation Front view Back View Remote Controller Introducing the menu Turning the Power On/Off To turn the power on/offTo enter into menu TuningTo preset channels Auto search To preset channels Manual search Manual searchTo skip a position number To restore skip a position numberMFT Manual Fine Tuning Setting of colour system Channel selection To watch a TV programmeSelectable picture To select the picture modeConvenient Picture Controls To set the desired picture quality to the Personal positionSleep timer Convenient Sound Controls and Sleep timerAdjusting the volume and muting the sound Colour system selection System settingTo select the language for the OSD Blue backgroundPlaying games Special functionsCalendar function To play GAME1 GobangTo play GAME2 Falling Cube OFF Time setting NOW Time settingOn Time setting On Channel settingChannel reservation Time settingChannel setting To reserve the channelExternal Equipment Connections To connect AV input terminalTo connect Monitor output terminal TV Video 1 Video 2 Video 3 S-VIDEOSymptoms Check the following items Troubleshooting GuideSpecifications Australia 1300 657