First Time Configuration/Basic Operations
Initial setup
The first time you use the TV, you need to configure your TV.
To configure your TV:
1Make sure that you have inserted the batteries in the remote control, have connected your antenna to the TV properly, and have connected the AC power.
Installation Guide
OSD Language | English |
Channel Tuning |
|
OK Start | Exit Exit |
Channel Tuning
2 %... 78.50MHz ATV
ATV : 2 Programme(s)
DTV : 0 Programme(s)
Radio : 0 Programme(s)
Press <Menu> to skip.
Press <Exit> to exit.
2Press the Power Switch on the TV, then press POWER 
to turn on the TV.
3Now the Installation Guide screen appears with Channel Tuning highlighted. Press OK to begin the auto tuning for all available channels, first for ATV then DTV (including Radio) channels. It may take several minutes, please wait until it is finished.
During searching, the screen will display a report about found stations.
When complete, it will go to digital programme position one. Now channel list has been created and you can start to watch TV.
Note: During ATV tuning, if you want to skip it and go to DTV tuning, press MENU. To exit tuning, press EXIT.
Turning the TV on or off |
Power Switch |
To turn the TV on or off:
1Plug the power cord into an AC power outlet. Press Power Switch on the TV.
2Now the set is in standby mode. Wait some seconds until the power indicator lights up, then press POWER 
to turn on the TV. (Be sure to wait some seconds before pressing POWER button. If you promptly press POWER button then the TV may not respond or act wrongly.)
3Press 
button again to turn off the TV and put the TV in standby mode.
To cut off the power completely, press Power Switch on the TV.
Warning: When the TV is in standby mode, power is still flowing into the TV. To save power, please press Power Switch to completely cut off the power. After you turn off the TV, you should wait at least 5 seconds (the power indicator goes out)before you turn it on again.
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into standby mode automatically.
15