Palsonic 5169M owner manual Search, Manual search Manual, STD colour system selection

higher band in the sequence of VL VH U with the green bar moving rightward. When a station is located, the set will store the signals with a channel number from 0. When all the signals are searched and stored, the TV returns to 0 channel automatically, auto-search is finished.

*After auto-search, all programs colour system is set to AUTO and in AFT-ON mode.

*During the process of auto-search, if MENU or CH button is pressed, the searching is

interrupted. Press VOL button the searching begins again.

7) SEARCH

Making use of SEARCH function will store a TV program at a referred channel position.

Select a channel number, when SEARCH is highlighted, press VOL button, the set begins to search for signals upward or downward from current channel. When a station is located, the searching stops and the program is stored into the referred channel position.

Repeat the above step and store another program signals into another position. If two channels are same, the previous will be deleted.

When the searching is finished, to store the program signals you should press the MENU button to exit the menu and the program signals are stored automatically.

*When the tuning changing reaches the highest (lowest), the searching turns to next band’s lowest (highest) and continues searching. If the signals are not the signals you desire, you can press the

VOL button again until the desired signals are searched.

8) Manual search (MANUAL)

When some program’s picture or sound is not good, you can make use of this function to fine tune the tuning voltage.

Press CH button to highlight MANUAL. Press VOL successively, the set begins searching upward or downward. When the picture has obtained the optimum effect, release the button.

To store the effect you should press the MENU button to exit the menu and the effect is stored automatically.

3. FUNCTION menu
	STD	AUTO
	SYS	1
	BLUE	ON

Making use of the FUNCTION menu can select BLUE ON/OFF and current channel’s colour and

sound system.
Press CH	button to select item (the selected item is highlighted). Press MENU button to exit

to the main menu.

1) STD (colour system) selection.

If the picture's colour system is abnormal, please select and highlight. "STD AUTO". Then press

VOL button to select proper system (AUTO PAL N358 N443) to achieve normal colour.

10