Connections
Tips
Depending on your TV and other equipment you wish to connect, there are various ways you could connect the player. Use only one of the connections described below.
Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.
For better sound reproduction, connect the player’s AUDIO OUT jacks to the audio in jacks of your amplifier, receiver, stereo or audio/video equipment. See “Connecting to Optional Equipment”
on page
Caution
–Make sure the DVD Player is connected directly to the TV. Tune the TV to the correct video input channel.
–Do not connect the DVD Player’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
–Do not connect your DVD Player via your VCR. The DVD image could be distorted by the copy protection system.
Connecting to a TV
Make one of the following connections, depending on the capabilities of your existing equipment.
Video connection
1Connect the VIDEO OUT jack on the DVD Player to the video in jack on the TV using the video cable (V).
2Connect the Left and Right AUDIO OUT jacks of the DVD Player to the audio left/right in jacks on the TV (A) using the audio cables.
1Connect the
2Connect the Left and Right AUDIO OUT jacks of the DVD Player to the audio left/right in jacks on the TV (A) using the audio cables.
Component Video (Color Stream®) connection
1Connect the COMPONENT VIDEO OUT jacks on the DVD Player to the corresponding in jacks on the TV using an Y, CB/PB, CR/PR cable (C).
2Connect the Left and Right AUDIO OUT jacks of the DVD Player to the audio left/right in jacks on the TV (A) using the audio cables.
Notes
–Refer to the owner’s manual of your TV as well.
–Before you connect the DVD player to your TV, be sure to turn off the power and unplug both units from the wall outlet before making any connections.
Progressive Scan (Color Stream® pro) connection
If your television is a
If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD Player.
1the DVD Player to the corresponding in jacks on the TV using an optional Y, CB/PB, CR/PR cable (C).Connect the COMPONENT VIDEO OUT jacks on
2the DVD Player to the audio left/right in jacks on the TV (A) using the supplied audio cables.Connect the Left and Right AUDIO OUT jacks of
Notes
–Set the Progressive to “On” on the setup menu for progressive signal, see page 15.
–Progressive scan does not work with the analog video connections (yellow VIDEO OUT and
Rear of TV
| COMPONENT VIDEO / | AUDIO INPUT | VIDEO | ||||
INPUT | PROGRESSIVE SCAN INPUT | INPUT | |||||
|
| ||||||
| Pr | Pb | Y | L | R | L | |
S CA V
Rear of DVD player
Caution
–Do not set the Digital Audio Output of this DVD player to “Dolby Digital” unless you are connecting the DIGITAL OUT jack of this DVD player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers.
10