Humax IHDR-5200C user manual Connecting the Network

Quick Start Guide

Connecting the Network

Connecting to the LAN;

Connect one end of the Ethernet cable to the product and the other end to the LAN router.

Connecting to the Wi-Fi (Wireless LAN); (Reserved for future use.)

You can connect the network via the Wi-Fi access point or DSL/cable modem.

1.Plug in the wireless USB dongle to the USB port. (Separate purchase required)

2.Set the options for the Wi-Fi.

Network Name (SSID): Select the network name of your Wi-Fi access point from the list.

Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security type of the Wi-Fi and the product shall be set the same.

Password: When using the security type, you must set the password. Enter the same password in the Wi-Fi setting menu.

3.After completing the Wi-Fi access point setting, make sure the settings in Installation Wizard or Settings>System>Network>Configure Wi-Fiare the same.

Note:

•Make sure the distance between the Wi-Fi access point and the product is not too far away. This may lower the quality of service.

•It is recommended to purchase a wireless USB dongle distributed by HUMAX. Other products may not function or respond. Visit the HUMAX website to find the information on purchasing a wireless USB dongle. (http://www.myhumax.nl)

2 1

WLAN USB Dongle

Ethernet Cable

LAN

Wireless Router Router

Note: We recommend the network connection over a direct LAN.

10