KTI Networks KC-300DM specifications Product Highlights, Specifications, Key Features

KC-300D, KC-300DM

Product Highlights :

Full wire speed performance

Comprehensive configuration options

Loop back test support

Remote TP link monitoring

Low power consumption

Loop back test support

Optional Din-Rail mounting

Center Chassis installation support

Options for Bi-Di communication

Options for CWDM

KC-3DR :

Din-Rail mounting bracket

KC-1300 :

Managed center chassis

10/100Base-TX to 100Base-FX Media Converters

The media converters are designed to convert 10Base-T or 100Base-T signals to/from 100Base-FX fiber signals. It is used to extend the connection distance between two Ethernet devices via fiber cable transparently with no performance degradation. The media converters not only support existing variety of multimode and single mode fibers but also support Bi-Di WDM and CWDM fiber network applications. It is also featured with design to support center chassis installation with optional power redundancy and management features when a larger fiber network is required.

Key Features :

Convert speed and media type in full wire speed

Support 10/100M dual speed on TP connections, auto-negotiation, and auto-MDI/MDI-X detection

Link fault pass through function

Transparent to 802.1Q VLAN tagged packets

Far End Fault function on FX port

Support desktop,wall, and DIN-rail mounting

Support center chassis installation

Low power consumption

Support wide range of fiber options

Provide user accessible settings for TP port configuration,disabling link fault pass through function

KC-300DM Specific

Provides indications of remote media converter's TP port status

Provides Loop Back Test function with connected remote media converter

Specifications :

TP Port	IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX
	Shielded RJ-45 jacks with Auto MDI/MDI-X detection
	Auto-negotiation for speed and duplex auto detection
	Forced mode with speed and duplex settings
	Speed for 10Mbps or 100Mbps, Full-duplex or half-duplex support
FX Port	IEEE 802.3u 100Base-FX compliant
	Forced 100Mbps, Full duplex (factory default)
	Far end fault Function
Cable	Cat. 5 UTP cable, MMF - 62.5/125µm, 50/125µm, SMF - 9 /125µm
LEDs	KC-300D :	Power status
	TP Ports :	Link/Act, Speed, Duplex status
	FX Ports :	Link/Act status, Fiber signal detected
	KC-300DM:	Power status
	TP Ports :	Link/Act, Speed, Duplex status
	FX Ports :	Link/Act status, Fiber signal detected
	Remote TP Ports : Link, Speed, Duplex status

080110