FUNAI V07LCD26 5Still Mode, 5Switching Each Mode, You can freeze the image shown on the TV screen

Page 16

WATCHING TV

5Still Mode

You can freeze the image shown on the TV screen.

Press [STILL] to pause the image shown on the screen.

Still

•The sound output will not be paused.

•If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted.

•The still function will be released after 5 minutes.

To cancel still mode, press any button except [POWER].

5Switching Each Mode

You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access an external device when they are connected to the unit.

Press [INPUT SELECT] or [CH K] repeatedly to cycle through the input modes.

TV/DTV channel

Video1

or

Video2

Component1

Component2

HDMI

•Pressing [CH L] reverses the direction of the mode.

•To use the video or S-video input jack of VIDEO 1 on the unit, select “Video1”.

•To use the video or S-video input jack of VIDEO 2 on the unit, select “Video2”.

•To use the component video input jack of COMPONENT 1 on the unit, select “Component1”.

•To use the component video input jack of COMPONENT 2 on the unit, select “Component2”.

•To use the HDMI - IN jack on the unit, select “HDMI”.

16

EN

Page 15 Page 17
Image 16
Page 15 Page 17
Contents
V07LCD26 Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV Interference5Supplied Accessories 5Symbols Used in this ManualRemote control LocationFeatures DTV/TV/CATV5Remote Control Function 5Installing the BatteriesControl Panel Rear PanelConnection 5Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxHdmi Connection 5External Device ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionVideo Connection AnalogInitial Setting 5Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing of channels start automatically5Main Menu 5Auto Channel Scan5Language Selection Press Setup to exitLanguage 5Volume Adjustment What is the minor channel?Watching TV 5Channel Selection5Still Mode 5Switching Each ModeYou can freeze the image shown on the TV screen To use the Hdmi in jack on the unit, select Hdmi5Switching Audio Mode StereoSAP Mono5Screen Information Press InfoBroadcasting Information Day of Memoriesi5TV Screen Display Mode Press Sleep to set the sleep timer 5Sleep TimerTo Cancel the Sleep Timer Optional Setting 5Channel List 5Manual RegisterChannel registration list Use Cursor K/L to select Channel List, then press Enter5Antenna Confirmation Antenna5Picture Adjustment Picture ModeReset Settings Color Temp5Closed Caption DTV CC 5DTV Closed CaptionUse Cursor K/L to select DTV CC, then press Enter Font Style 5CC StyleFont Size Font Color Font OpacityBack Color Back OpacityChipip Enter password ChipUse Cursor K/L to select V-chip, then press Enter ChipipPress Setup to exit View and BlockTo Set the Sub Ratings As for TV-MA, TV-14, TV-PG, or TV-Y7, you can furtherUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm password5HDMI Audio You can set the method of sound input for the Hdmi in jackTroubleshooting 5Troubleshooting GuideCheck the batteries of the remote control Refer to IR Signal Check onInterrupt the remote control signal of this unit Delayed behind the dialogueMaintenance InformationGlossary Atsc5General Specifications 5Electrical Specification5Other Specifications 5Cable Channel DesignationsLimited Warranty