Jasco RM94902 manual Trouble Shooting, To Program Sleep Feature, To Turn Off The Sleep Timer

Sleep Feature

This feature will turn off your TV at the time you choose from 1 to 99 minutes.

Trouble Shooting

Problem	Solution
Indicator light not blinking	A) Replace the batteries (with
when you press any key	fresh, new AAA Alkaline

To Program Sleep Feature:

1.Press and hold the SLEEP button. INDICATOR LIGHT will stay lit. Release the SLEEP button.

2.Enter time in minutes using the numerical key pad.

(Minutes 1 thru 9: press 0 before the actual number)

(Maximum: 99 minutes)

3.Leave remote aimed at television. (Sleep Feature will not work unless remote is left aimed at television.)

INDICATOR

LIGHT

SLEEP

1 2 3

4 5 6

7 8 9

0

A¥BSLEEP

		batteries).
	B)	Check that batteries are
		properly installed.
The RM94902 does not	A)	Try all the codes listed for
operate your device		your brand.
	B)	Try the Code Search
		method (page 11).
Not performing commands	Start Code Search over again to
properly	locate the proper code.
Problems programming a	Try the VCR code for your
TV/VCR Combo Unit	brand. Some combo units,
	however, may require both a
	TV and a VCR code for full
	operation.
VCR not recording	As a safety feature on your
	remote, you must press the
	REC button twice.
Channel up and down do not	Due to some designs, the

To Turn Off The Sleep Timer:

Sleep timer program will be cancelled and reset to zero by either of the following:

Press and hold SLEEP button until INDICATOR LIGHT blinks or press POWER button, turning TV OFF.

POWER

SLEEP BLINK

function on an RCA TV	original remote will only
	perform these functions.
Problems changing channels	If your original remote required
	ENTER after a channel, press
	ENTER after you select a
	channel.
No response after pressing	A)	Make sure you have new
a key		batteries, and you are
		aiming your remote at
		your devices.
	B)	Check that batteries are
		properly installed. See
		page 3.
Sleep feature does not work	Remote must remain aimed at
	television after sleep is set in
	order for it to work.

Reprogramming may be required after batteries are removed.

12 13