Why You Should Use the Auto Tuning Feature

RCA F27669 manual Why You Should Use the Auto Tuning Feature, PIP Troubleshooting

Using the TV’s Features

TV (back panel)

VIDEO		AUDIO
VIDEO	R	L / MONO
	R	L / MONO
		IN
	R	L
		OUT
		CABLE/
G-LINK		ANTENNA
		S-VIDEO

VCR

VIDEO	AUDIO		IN FROM ANT
	OUT		CH3
	OUT		CH4
	R	L	CH4
	R	L	OUT TO TV
	IN		OUT TO TV
	IN
	R	L

You must use audio/video cables to connect your VCR to your TV in order for PIP to work.

TV channel PIP channel (VID) is from VCR

To change the PIP channel, press the channel buttons on the VCR. To change the TV channel, press CH CTRL until the TV channel is highlighted (yellow) and press the CH up and down buttons.

VCR1TV

DVD VCR2 AUX SAT CABLE

PIP Troubleshooting

•The PIP feature on this TV only works if you connect a second video source (like a VCR or satellite receiver), to your TV with audio/video cables. If you use a cable box, you may need extra equipment. Contact your cable company and/or go to page 12 for more details about a cable box connection.

•Swap won’t work? Make sure the remote is in the right mode. For example, once you turn on the VCR with the VCR1 button, you can’t SWAP the pictures until you put the remote in TV mode. Just press the TV button.

•No signal or bad reception? Most VCRs and satellite receivers have an antenna or TV/VCR button. Press the antenna or TV/VCR button on the front of the component.

Note: If you programmed the Universal remote control to operate your VCR, the ANTENNA button on the remote acts as a TV/VCR button.

•Every time you change channels, the same channel appears in both windows (the main picture and the PIP picture).

A.Press the CH CTRL button on the remote until the TV picture channel number is highlighted (yellow). The channel buttons on your remote control won’t work correctly for PIP when the VID channel is highlighted (yellow).

B.The only way to successfully change channels for the picture that is coming from the channel on your VCR (the VID channel), is to press the channel buttons on the VCR or on the VCR’s remote control.

Why You Should Use the Auto

Tuning Feature

With the auto tuning feature, you can set up the TV to tune to the channel you need to watch by pressing that component’s button.

TV MAIN MENU

1 Audio

2 Picture Quality

3Screen

4 Channel

5 Time

CHANNEL

6 Parental Controls

7 GUIDE Plus+ Menu

1 Signal Type

8 Setup 2 Auto Channel Search

0 Exit 3 List and Labels

4 Auto Tuning

0 Exit

The auto-tuning feature automatically tunes the TV to the correct channel for different components you have connected to your TV (like a VCR, DVD Player, etc.) When you set up auto tuning in the menu system you don’t have to remember to change your TV to channel 3, for example, when you want to watch the tape in your VCR.

How to Set Up the Auto Tuning Feature

The way you set up the auto tuning feature in the TV’s menu corresponds to the component buttons on the remote and the way you have each component connected to your TV. When you set auto tuning, you’re telling the TV what channel to tune to when you press the VCR1, VCR2, DVD, or SAT•CABLE button on the remote control.

1.Press MENU (the TV MAIN MENU appears).

2.Highlight Channel and press OK on your remote control.

3.Highlight Auto Tuning and press OK.

Chapter 3