Jensen CR560X Testing, Reconnect Battery, Test Power Wiring, Test Antenna Connection

®

CR560X

✓Testing

Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly.

Reconnect Battery Test Memory Wiring

When wiring is complete,
reconnect the battery
negative terminal.	+
	—

Test Power Wiring

1.Turn ignition switch on. Press the (Power) button to turn the radio on. The display should light and show the radio display. If not, check the electrical connection at the yellow and red wires.

2.If equipped, the power antenna should also operate. If not, check electrical connections to the dark blue wire.

Test Antenna Connection

1	1	1. With the radio playing, hold
		button 1 for two seconds.

CH 1 will appear on the display. You just stored the current station in memory.

2.Turn the key off, then turn the key on again.

2

3.The radio should resume playing at the same station

and volume. If not, make sure the yellow wire is connected properly.

Set the Clock

Press DISP button to display the clock.

1	DISP	1.	Press DISP button for
			three seconds until
			display flashes.
		2.	Press to change

1

1. Hold a tuning button

for more than two

minutes, to change

2

or

VOL +

seconds. The radio

should tune to a

nearby station. If

not, check antenna

connection.

2. Press + to increase

volume until you

can hear the radio

playing.

hours.

2

M H

8

5588 CR560X_EIN.p65 8 2/29/00, 10:46 PM