V. SIZE ADJUSTMENT (VSIZ)
1.Input a crosshatch signal.
2.Activate the Service Adjustment Mode.
3.Select the VSIZ item with 1 and 4 .
4.Adjust value of VPOS with 1 and 4 for the best vertical center.
5.Press MUTING then ENTER to save into the memory.
V. CENTER ADJUSTMENT (VPOS)
1.Input a crosshatch signal.
2.Set to Service Adjustment Mode.
3.Select the VPOS item with 1 and 4 .
4.Adjust value of VPOS with 3 and 6 for the best vertical center.
5.Press MUTING then ENTER to save into the memory.
H. CENTER ADJUSTMENT (HPOS)
Perform this adjustment after performing H. Frequency.
1.Input a crosshatch signal.
2.Set to Service Adjustment Mode.
3.Select the HPOS item with 1 and 4 .
4.Adjust the value of HPOS with 3 and 6 for the best horizontal center.
5.Press MUTING then ENTER to save into the memory.
V. LINEARITY (VLIN), V. CORRECTION
1.Input a crosshatch signal.
2.V.Correction is automatically adjusted from the circuit and should satisfy the conditions below.
V LINEARITY (VLIN)
V CORRECTION
SERVICE ADJUSTMENT MODE MEMORY
1.Change the value of the DCOL item to 1.
2.After completing all adjustments, press 0 then ENTER .
Read From Memory
Mode
SERVICE | READ |
| Green |
| |||
|
| 0 | |
|
|
| Red |
|
|
|
|
|
|
| ENTER |
|
|
|
|
— 20 —