Channels
Problem | Possible Remedies |
Cannot receive upper | ❏ Change the Cable option to Off (see page 66). |
channels (UHF) when | ❏ Use Auto Program in the Channel Menu to add receivable channels that are |
using an antenna | not presently in the TV’s memory (see page 66). |
|
|
TV is fixed to one channel | ❏ Use Auto Program in the Channel Menu to add receivable channels that are |
| not presently in the TV’s memory (see page 66). |
| ❏ Check your Channel Fix settings (see page 66). |
|
|
Cannot receive any | ❏ Use Auto Program in the Channel Menu to add receivable channels that are |
channels when using | not presently in the TV’s memory (see page 66). |
cable TV | ❏ Make sure the Cable option is set to On in the Channel Menu (see page 66). |
|
|
Cannot receive or select | ❏ Use Auto Program in the Channel Menu to add receivable TV channels that |
channels | are not presently in TV memory (see page 66). |
|
|
General
Problem | Possible Remedies | |
How to reset TV to | ❏ | Turn on the TV. While holding down the RESET button on the remote |
factory settings |
| control, press the POWER button on the TV. (The TV will turn itself off, then |
|
| back on again.) Release the RESET button. |
|
| |
How to restore Video settings ❏ | Press the RESET button on the remote control while in the Video Menu (see | |
to factory settings |
| page 62). |
|
|
|
How to restore Audio | ❏ | Press the RESET button on the remote control while in the Audio Menu (see |
settings to factory settings |
| page 64). |
|
|
|
Cannot cycle through the | ❏ | Be sure the Video Label option is not set to Skip (see page 73). |
other video equipment |
|
|
connected to the TV |
|
|
Cannot operate Menu | ❏ | If a menu option appears in gray, this indicates that the TV is in a state in |
|
| which the menu option is not available. |
|
|
|
Lost password | ❏ | In the password screen (see page 68), enter the following master password: |
|
| 4357. The master password clears your previous password; it cannot be |
|
| used to temporarily unblock channels. |
|
| |
TV makes “popping” sound ❏ | This is a normal sound that results from the TV automatically degaussing | |
when turned on |
| each time it is turned on. |
|
|
|
LED on front panel is lit | ❏ | The STAND BY LED (see page 11) blinks when the TV is turned on, then |
|
| shuts off when the picture is displayed. If the LED blinks continuously, this |
|
| may indicate the TV needs service. |
| ❏ | The TIMER LED (see page 11) indicates that the timer is set (page 71). |
|
| When the timer is set, this LED will remain lit even when the TV is turned |
|
| off. |
|
|
|
SETUP
SETUP
SETUP
Other Info
81