RCA 27000 manual Quick Guide to Your TV, Startup, Hook up your TV, Put batteries in the remote

Page 4

Quick Guide to Your TV

Startup

The steps below will get your TV connected and ready for watching. For more details, see the page numbers listed.

1. Hook up your TV

Details are in the

Connections Guide.

Use This Book First!

CONNECTIONS

GUIDE

THIS GUIDE

SHOWS HOW

TO HOOK UP

YOUR TV

AND OTHER

COMPONENTS.

Hook up any antennas, cables or other equipment to your TV before you follow the steps below. This is where to find the instructions for SVHS, a super VHS recording format that improves the picture quality. It is found on some VCRs and camcorders.

To Find

Your Hook-up

Turn To

Page 1

CAUTION: If you choose not to use the stand recommended for your TV, take precautions that the stand or furniture the TV is placed on is properly located and of adequate size and strength to prevent the TV from accidentally being tipped over, pulled off, or pushed off. This could cause damage to the TV and/or personal injury.

2. Plug in the TV

2a. Use this adaptor

for models RBA27550 and RCA27000

Plug the cord into the outlet, matching the wide and the small end of the plug with the outlet.

A.Plug the cord into the adapter that was packed with your TV as shown at the left.

B.Plug the adapter into the outlet, matching the prongs with the outlet.

3. Put batteries in the remote	A. Pull off the cover of the battery
	compartment.

B. Place the four AAA batteries as shown, matching the + and – end of each battery in the com- partment.

C. Replace the cover.

2

Image 4

Contents USER’S Guide Service Personnel Important InformationTable of Contents Quick Guide to Your TV StartupHook up your TV Put batteries in the remotePlace all available channels in memory Autoprogram Turn on the TVSet the time TV Power Button Volume and Channel Controls Basic Tour of the RemoteComponent Buttons Menu ButtonsMenu Basics ColorsMoving through the Menus Yellow Green Light White BlueUsing Your TV and Remote With Remote ButtonsNumber Buttons AntennaWith VCRs Programming the Remote Test the remoteProgram the remote for Your VCRsWith VCRs Setting the VCR 1 Channel Select the Setup MenuDiagram used from Set VCR 1 Channel to Connection Guide Highlight VCR1 ChannelWith VCRs Basic Operation Turn on the VCR Turn off the VCRRecord one TV program and watch another Watch a tape in your VCRSatcable and then Power With a Satellite Receiver Basic OperationWith a Cable Box Programming and Basic Operation Program the remote for your cable boxBasic Operation Turn on the Cable Box Turn off the Cable BoxWith a Cable Box Setting the Cable Channel Select the Setup menu Highlight Cable ChannelWith a Laserdisc Player Programming and Basic Operation VCR2LD and then PowerLaserdisc Player Codes Audio and then Power With Audio Equipment Programming and Basic OperationProgram the remote for audio equipment Audio CodesAdjusting Your TV Use Move E and F to adjust the PictureOverall Picture Select the Controls MenuPicture Settings Adjusting Your TV Sound Settings Stereo and ToneStereo Off Tone High LowPlacing Channels in Memory Autoprogramming Using Advanced FeaturesPlace channels in memory Autoprogram Add or delete channels Naming the Channels Name a channelErase a name Character ListUsing Advanced Features Setting the Sleep TimerSet Sleep Timer Cancel the TimerSetting the Alarm Clock Turn on the AlarmSet the Alarm Channel Set On and Off TimesSelecting a Language Select the Setup menu Select LanguageWatching Closed Captioning Highlight Cable/Air Setting Your TV for Antenna or CableSelect Cable or Air References Front Panel ButtonsDisplays on the Screen Screen Display DescriptionTrouble Checks and Adjustments Power Trouble ChecksPicture SoundTrouble Checks and Adjustments Remote TV Turns on or offReferences IndexCountry of Origin