Pioneer RCS-505H, RCS-606H, RCS-404H manual Initial Setup menu, Rgb

The Initial Setup menu

Setting	Options	Explanation
Tuner
Auto Channel	Auto Scan	Select your country and then wait for the recorder to auto tune into channels in
Setting		your area. After auto scan has finished, the channel mapping screen appears
		showing which channels have been assigned to which program numbers. You
		can skip unwanted channels using the Manual CH Setting option below.
		Press HOME MENU to exit the channel mapping screen.
	Download from	If your TV supports this feature you can download all the channels that your TV is
	TV	tuned to via the SCART input. Select your country and then wait for the down-
		load to complete. After the download is complete, the channel mapping screen
		appears, as above.
		See also the operating instructions that came with your TV for more information.
Manual CH Setting	Next Screen	Proceed to the next screen if you need to adjust any of the settings made by auto
		tuning. Select your country, then proceed to the manual channel setting screen:
		• Change channel presets using the	buttons.
		• To skip the displayed channel (because there is no station assigned to that
		channel), change the Skip setting to On.
		• Set the CH SYSTEM setting to match the channel system of your country or
		region.
		• Set the CHANNEL setting to the channel you want to assign to the current
		channel preset.
		• To manually fine tune the channel, change the AFT setting to Off then adjust
		the Level setting.
		• Set the Sound System setting to match the sound system of your region.
		• The Name field allows you to input a name of up to five characters for the
		current channel preset.
		• If the currently selected channel is scrambled requiring a decoder connected
		to the AV2 (INPUT 1/DECODER), set the Decoder setting to On.
Channel Swapping	Next Screen	Proceed to the next screen to swap channel assignments of different presets so
		that you can group together presets that naturally go together. Select two
		presets to swap then press ENTER.
Video In/Out
Input Colour	Next Screen	Proceed to the next screen to set the input colour system for the external input
System		and the built-in TV tuner. Use the CH +/– buttons to change the preset. On the
		default Auto setting the recorder can generally correctly detect whether the
		input signal is PAL, SECAM, 3.58 NTSC or PAL-60, but in some cases you may
		have to set it manually if the picture is displayed incorrectly.

See also About the input colour system on page 135 for more information on this setting.

Component Video Interlace •		Select if your monitor/TV is not compatible with progressive-scan video.
Out
	Progressive	Select if your monitor/TV is progressive-scan compatible. Check the operating
		instructions that came with your monitor/TV if you’re not sure.

For Component Video Out to be effective, the AV1 Out setting (see AV1 Out below) must be set to something other than RGB.

AV1 Out	Video •	Sets the AV1(RGB)-TVSCART output to standard composite video (compatible
		with all TVs).
	S-Video	Sets the AV1(RGB)-TVSCART output to S-video. Recommended if you are using
		a long SCART cable.
	RGB	Sets the AV1(RGB)-TVSCART output to RGB. Good quality but check your TV for
		compatibility. Note that on this setting signals from the built-in tuner and from
		external inputs is not output when the recorder is in TV mode.

15

English

129

En