Chapter 1: Connections & Setup
ON•OFF Turns the power of the active device (either the TV or VCR) on or off.
PAUSE Pauses playback and recording in VCR mode.
PLAY Starts tape playback in VCR mode.
REC Starts recording in VCR mode.
REV Rewinds a tape. In Playback mode, pressing and holding REV starts reverse scan playback. In Stop mode, pressing REV
SEARCH In stop mode, displays Index Search and
Each press after that advances the tape’s playback through 30 seconds of recorded material (up to five minutes).
SPEED Changes the recording speed (either SP or SLP).
STOP Stops the active function of the VCR including tape playback, recording rewinding, and
TRACK +/– (up and down) buttons Allows the manual reduction of streaks which may appear on the picture during regular or
TV Puts the remote control in TV mode. This button will automatically turn on most RCA, GE, Proscan, and Scenium TVs.
VCR Puts the remote control in VCR mode.
VOL+/VOL- buttons Decreases or increases the TV volume.
Using the INPUT Button
Use the INPUT button to toggle through the available Video Input Channel sources (Video1 and Video2) and regular broadcast signals. The Video Input Channels allow you to view images from a device connected to your VCR (like a camcorder).
1.Press the remote control’s VCR button to activate VCR mode. Make sure that the VCR is turned ON.
2.Press the remote control’s INPUT button to tune to the Video Input Channel. Video1 represents the rear A/V jacks and Video2 represents the front A/V jacks.
3.Press the INPUT button again to tune back to the broadcast signal you were previously watching through the VCR.
12 | Chapter 1 |