SETUP AND CONNECTIONS
ADVANCED CONNECTIONS
Advanced connections give you better sound and video by separating the audio and video signals and enable you to connect multiple components.
This section describes the types of inputs available on the back of your TV and suggests ways you can use them for optimum performance.
Once you have made your connections you will want to program the TV to tune to the correct Video INPUT channel in order to see and hear audio and video from the component. You will program this later in the Interactive Setup.
Back of the TV
The diagram below describes each of the back panel jacks. When connecting A/V cables, be sure to connect corresponding OUTPUTS and INPUTS (Video to Video, Right Audio to Right Audio, etc.).
Input 2 (VIDEO or Y PB PR)
Connect any of the following components to INPUT 2:
• VCR | • Internet Access Device |
• Laserdisc Player | • DVD Player |
•Satellite Receiver
| Input 1 | The Y, PB, PR jacks are used in place of the VIDEO jack to connect |
Connect any of the following components: | an optional component video source, such as a DVD player. Unlike | |
a single video input, the Y, PB, PR jacks maintain the video signal as | ||
• VCR | • Internet Access Device | three separate signals through these three jacks. To ensure |
• Laserdisc Player | • DVD Player | maximum picture quality, use three |
• Satellite Receiver |
| PB, and PR connections. |
To view the component connected to Input 1: | To View the component connected to Input 2: | |
Use the WHO•INPUT button on the remote. | Use the WHO•INPUT button on the remote. |
|
|
| External Speaker Jacks | |
|
|
| Use to connect external | |
|
|
| speakers for surround | |
R | L | sound. Make sure the | ||
| ||||
This optional |
|
| Speaker Selection is set | |
connection can be | PRPBY | |||
to EXTERNAL. | ||||
used for better |
|
| ||
|
|
| ||
video quality |
|
|
| |
picture. |
|
|
| |
|
|
| Connect the | |
|
|
| cable for one- | |
Audio Outputs |
| Cable/Antenna | button recording | |
| and channel tuning | |||
|
|
| ||
Connect to an audio receiver | Takes the signal input from a cable, | from the Guide. | ||
or amplifier for variable | cable box, or an |
| ||
controlled or fixed level | also be used for basic component |
| ||
stereo output. | connections. |
|
6