RCA R52WH73 manual Digital and Analog Channels, Autotuning, Digital Channels

Using the TV’s Features

Tip:

Look at the channel number to determine whether you're on the digital or analog input. A 'D' appears next to channel numbers on a digital channel, while an 'A' appears next to channel numbers on the analog channel.

Digital and Analog Channels

Your TV can choose both, analog and digital channels. You can switch between the two by pressing the ANT•CABLE button on your remote control when the remote is in TV mode.

4/3 format Mono English cc 03:45 pm

Program title

Program description...

15-1 NBC-HD

15-1 NBC-HD

Digital Channel

Primary Channel

Subchannel (if necessary)

Digital Channels

Digital channels can be made up of primary channels and subchannels. Subchannels (sometimes called minor channels) are channels associated with the Primary channel (sometimes called the major channel). A primary channel may have just one subchannel or multiple subchannels.

Direct Tuning to a Digital Channel

1.Make sure the remote is in TV mode by pressing TV on the remote control.

2.Press ANT•CABLE until a "D" icon appears next to the channel number.

3.Enter the primary channel number. This number appears first. Press OK or wait a few seconds. If you don’t enter a subchannel, the TV tunes to the lowest digital subchannel.

4.If the primary channel number has fewer than two digits, and you want to enter subchannel numbers, press the right arrow button to enter the subchannel.

5.Enter the number of the subchannel. This number appears to the right of the primary channel number.

6.Press OK to tune to the channel or wait a few seconds and the TV tunes to the channel.

Note: Once you've run the auto channel search, you can just use the channel up and down buttons on the remote control to change channels when the remote's in TV mode.

ON•OFF

SAT•CABLE AUX DVD TV

GO BACK

VOLCH

MUTE

Your remote's device buttons

Autotuning

The autotuning feature works with RCA devices to automatically tune the TV to the correct channel/input. It works with devices you have connected to your TV (like a VCR, DVD player, etc.). When you set up autotuning in the menu system you don’t have to remember to change your TV to the CMP1 input, for example, when you want to watch a DVD on your DVD player.

Why You Should Use the Autotuning Feature

Autotuning lets you go directly to the input you assign to a device button. For example, if you have a DVD player connected to the CMP1 input, you can have the autotuning feature go directly to the CMP1 input when you press the DVD button (instead of going through the inputs until you find the DVD signal).

Continues on next page...

Chapter 3 33