RCA 46LA45RQ manual Safety Strap

Page 4

Safety Precautions

23.WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation instructions.

24.To reduce the risk of electric shock, the grounding of center pin of plug must be maintained.

25.If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA NO.70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrodes. (See Diagram Figure A.)

 

ANTENNA

 

LEAD IN

 

WIRE

 

GROUND CLAMP

 

ANTENNA

 

DISCHARGE UNIT

 

(NEC SECTION 810-20)

 

GROUNDING CONDUCTORS

 

(NEC SECTION 810-21)

 

GROUND CLAMPS

ELECTRIC SERVICE

POWER SERVICE GROUNDING

EQUIPMEN T

ELECTRODE SYSTEM

 

(NEC ART 250, PARTH)

Diagram Figure A

Safety Strap

Caution: Pushing, pulling or climbing on the TV may cause the TV falling. Do not let chlidren climb or hang on the TV. Always place the TV on a sturdy, level, sable surface that can hold the weight of TV. And if possible, secure the TV according to the instruction below (Note: The fastening components such as screws are not supplied with TV).

Step one: Insert the M6 mounting screws into the upper two wall mounting screw holes and fasten them (Figure A).

Step two: Insert anchors to wall and connect the bolts and anchors with ropes or chains (Figure B).

Wall

M6 Screws

Figure A

Figure B

iii

Image 4
Contents Model Number LA45RQ FCC Notice Risk of Electric Shock Do not OpenSafety Precautions Safety Strap Table of Contents Product Specification Preparation for Your New TV Before Turning On TVTV Stand Installation Step OneStep Two Step ThreeTV Signal Connection Cable TV serviceAntenna Set-Top BoxCable Connections Choose Your ConnectionsSide Panel Connections Connecting AV Composite device Good Video QualityComposite Video Connection Connecting YPbPr Component device Better Video Quality Component Video ConnectionConnecting Hdmi device Best Video Quality Hdmi ConnectionHow to Obtain Various Kinds of Input Sources Connecting a computerPC Connection TV Jacks Explanation Side Keypad Buttons Side Keypad and Front PanelFront Panel Remote Control Reception Angle Remote Control InstructionsInserting Batteries in the Remote Learning about Remote Control Remote Control ButtonsInitial Setup Signal TypeMenu Language Auto Channel SearchAdjusting TV Stand Angle Basic OperationsTurning On and Off Choosing TV ChannelChannel Bar Adjusting VolumeEPG Electronic Program Guide OSD Menu Operations Adjust the OSD ScreenPicture Menu Screen Settings PC Settings only available in PC modeColor Temperature Advanced Picture Settings not available in PC modeSound Menu Equalizer Settings Channel MenuParental Menu Lock Parental ControlChip US V-ChipMovie Rating TV RatingCanada V-Chip English RatingFrench Rating Block Unrated ShowChange Password Front Panel LockSource Lock Clear Channel ListSetup Menu Setup Time ClockTime Zone Auto ClockNo Signal Power Off No Operation Power OffAll Reset Blue BackFrequently Asked Questions FAQs Are there other ways to view High Definition HD video?Troubleshooting Identifying ProblemsProblems with the Hdmi Connection Remote control doesn’t workYou are experiencing problems with V-Chip/Parental Controls Can’t select a certain channelUS V-Chip Rating System Chip Rating ExplanationsCanadian English V-Chip Rating System Universal Remote Control Code List Canadian French V-Chip Rating SystemWall Mounting Unit Specification ScrewProduct Specification Digital Cable 64/256QAM 1~135