RCA 24V510T manual DVD Button, Buttons, Play, Using Direct Entry Using Automatic Code Search

Using the Remote Control

	DVD		ON OFF
	VCR	TV	ON•OFF
DVD and			button
VCR	VOL		CH
buttons	MUTE	GO BACK
	CLEAR		MENU
		OK
	PRESETS		SKIP

	CC			INFO
	1	GUIDE	2	3
	4		5	6
	7		8	9
	INPUT		0	ANTENNA
	REVERSE	PLAY		FORWARD
	RECORD	STOP		PAUSE
REVERSE	AGAIN	ZOOM		OPEN CLOSE
and PLAY	SPEED	SEARCH		STOP
buttons				button

YouÕll use these buttons when programming the remote.

Using Direct Entry

Using Automatic Code Search

The following instructions can be used to program the remote to operate each of your components. If you want to stop the automatic code search without programming any of your components, press CLEAR until the indicator on the remote turns off.

1.Turn on the component you want to operate (VCR or DVD player)

2.Press and hold the component button you want to program (VCR or DVD). While holding the component button, press and hold ON¥OFF until the indicator on the remote turns on, then release both buttons.

3.Point the remote at the component. Press and release PLAY, then wait 5 seconds or until the indicator on the remote stops flashing.

At this point the remote is searching for the correct code to program. If, after 5 seconds, the component you want to operate does not turn off, press PLAY again to tell the remote to search the next set of codes.

Continue pressing PLAY until the component turns off or you have searched through all of the codes. There are 20 total sets of codes. If the component does not turn off after pressing PLAY 20 times, then the remote canÕt be programmed to operate that component.

If the component you want to operate does turn off:

1.Press and release REVERSE, then wait 2 seconds. Repeat this step until the device turns back ON.

2.To finish, press and hold STOP until the indicator on the remote turns off.

1.Turn on the component to be programmed.

2.Look up the brand and code number(s) for the component on the code list in this section.

3.Press and hold the component button you want to program on the remote.

4.Enter the code from the remote control code list on the following pages. If the indicator flashes, you have either entered an invalid code or the button isnÕt programmable.

5.Release the component button.

6.Point the remote at the component. Press ON¥OFF to see if the component responds to the command. If it doesnÕt, try pressing the component button and then ON¥OFF again.

¥If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.

¥If you try all the codes for your component brand and none work, try the automatic code search method. If automatic code search doesnÕt find the code, the remote is not compatible with your component.

Chapter 2 11