RCA 16-3054 manual Operation, Using the Radio, Using AN Earphone

Page 3

16-3054.auto.fm Page 3 Thursday, August 19, 1999 3:00 PM

Cautions:

You must use a power

!source that supplies 6V DC and delivers at least 520

mA. Its center tip must be set to positive and its plug must fit the TV's DC 6V jack. Using an adapter that does not meet these specifications could damage the TV or the adapter.

Always connect the DC adapter to the TV before you connect it to the power source. When you finish, disconnect the adapter from the power source before you disconnect it from the TV.

1.Set the adapter’s voltage switch to 6V.

2.Attach the adapter’s 4 mm outer diameter/1.7 mm inner diameter barrel plug, aligning + with TIP, and plug it into the TV’s DC 6V jack.

3.Unplug the vehicle’s cigarette lighter and plug the large end of the DC adapter cord into the cigarette-lighter socket.

Cautions:

Do not leave the adapter plugged into the cigarette-lighter socket or connected to the TV when you are not using the TV.

Always disconnect the adapter from the cigarette-lighter socket first.

Note: If the TV does not operate properly when you use DC power, be sure the cigarette-lighter socket is clean and that the adapter’s plug is properly connected to the socket.

OPERATION

1.Slide FM VHF AM UHF to either FM VHF or AM UHF to select the band.

2.Extend the telescopic antenna.

3.Slide TV OFF RADIO, located on the top of the TV, to TV. The TV starts scanning and stops at the next active channel in the selected band.

3

4. Press TUNING to tune to a different channel. The tuning line on the screen aligns with the selected channel number above the screen.

5.To adjust the volume, rotate VOLUME located on the top of the TV.

6.To adjust the picture to the desired brightness, rotate BRIGHT located on the top of the TV. The brightness also changes with the screen’s angle.

Notes:

If reception is poor, adjust the length or angle of the telescopic antenna. If inside a metal or concrete building, moving closer to a window might improve reception.

If desired, fold out the stand on the back of the TV and lean the TV on a flat surface at a convenient angle.

USING THE RADIO

1.Set TV OFF RADIO on top of the TV to

RADIO.

2.Slide FM VHF AM UHF on the TV’s right side to FM or AM.

3.Rotate the FM AM TUNING dial on the right side of the TV to tune to the desired station.

4.To adjust the volume, rotate VOLUME located on the top of the TV.

Note: Adjust the length, angle and direction of the antenna for the best FM reception. An internal antenna is used for reception of AM broadcasts.

USING AN EARPHONE

For private listening, you can connect an optional earphone with a 1/8-inch plug to the EAR jack. This automatically mutes the built- in speaker.

Image 3
Contents Color LCD TV with AM/FM Radio FeaturesBatteries PowerAC Power Using Vehicle Battery PowerUsing the Radio Using AN EarphoneOperation Listening Safely TroubleshootingTraffic Safety Using the TV AS a MonitorCare SpecificationsLimited Ninety-Day Warranty