Panasonic TC-L32G1 Size, Input signal that can be displayed, PC Input Terminals Connection

Technical Information (Continued)

H size

Aspect Ratio: 4:3

Size 1

Size 2

The width will be decreased on both sides to reduce noise.

Aspect Ratio: FULL/JUST(H-FILL/ZOOM)

			Size 1	Size 2	The width will be increased on both sides to
					reduce noise.
See pages 26-27 for more information
				Input signal that can be displayed
* Mark: Applicable input signal for Component (Y, PB, PR), HDMI and PC
				horizontal frequency (kHz)	vertical frequency (Hz)	COMPONENT	HDMI	PC
525		(480) / 60i		15.73	59.94	*	*
	525	(480) /60p		31.47	59.94	*	*
	750	(720) /60p		45.00	59.94	*	*
	1,125		(1,080) /60i	33.75	59.94	*	*
	1,125		(1,080) /60p	67.43	59.94		*
	1,125		(1,080) /60p	67.50	60.00		*
	1,125		(1,080) /24p	26.97	23.98		*
	1,125		(1,080) /24p	27.00	24.00		*
	640	× 400 @70		31.47	70.08			*
	640	× 480 @60		31.47	59.94			*
	Macintosh13” (640 × 480)			35.00	66.67			*
	640	× 480 @75		37.50	75.00			*
	852	× 480 @60		31.47	59.94			*
	800	× 600 @60		37.88	60.32			*
	800	× 600 @75		46.88	75.00			*
	800	× 600 @85		53.67	85.08			*
	Macintosh16” (832 × 624)			49.73	74.55			*
	1,024		× 768 @60	48.36	60.00			*
	1,024		× 768 @70	56.48	70.07			*
	1,024		× 768 @75	60.02	75.03			*
	1,024		× 768 @85	68.68	85.00			*
	Macintosh 21” (1,152 × 870)			68.68	75.06			*
	1,280		× 768 @60	47.70	60.00			*
	1,280		× 1,024 @60	63.98	60.02			*
	1,366		× 768 @60	48.36	60.00			*

Note

Signals other than above may not be displayed properly.

The above signals are reformatted for optimal viewing on your display.

PC Input Terminals Connection

Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)

Some PC models cannot be connected to the set.

There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.

The maximum resolution: 1,280 × 1,024

If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. Signal Names for D-sub 15P Connector

					Pin No.	Signal Name	Pin No.	Signal Name	Pin No.	Signal Name
	11	12	13	14	15	R		GND (Ground)		NC (not connected)
	6	7	8	9 10		G		GND (Ground)		NC
	1	2	3	4	5	B		GND (Ground)		HD/SYNC
48						NC (not connected)		NC (not connected)		VD
	Pin Layout for PC Input Terminal					GND (Ground)		GND (Ground)		NC