Panasonic TC-P50C1, TC-P42C1 Handling the power supply cord, Set up, AC Power Supply Cord

Page 5

WARNING/CAUTION

WARNING

Small parts can present choking hazard if accidentally swallowed.

Keep small parts away from young children.

Discard unneeded small parts and other objects, including packaging materials and plastic bags/sheets to prevent them from being played with by young children, creating the potential risk of suffocation.

When disconnecting the power supply cord, hold the plug, not the cord.

Do not use the power supply cord if the plug or cord is damaged.

Replace the cord or contact your Authorized Service Center

Handling the power supply cord

Insert the power plug fully into the socket outlet. (If the power plug is loose, it could generate heat and cause fire.) Ensure that the power plug is easily accessible.

Set up

This Plasma TV may fall and can cause personal injury or even death if not installed correctly. To prevent personal injury or death, follow these warnings:

Install the Plasma TV in accordance with the manufacturer’s recommended pedestal or stand, corresponding hardware and installation instructions.

This Plasma TV is for use only with the following optional accessories. Use with any other type of optional accessories may cause instability. The following accessories are manufactured by Panasonic Corporation.

Wall-hanging bracket (Angled) TY-WK4P1RW

Be sure to ask a qualified technician to carry out the installation and set-up.

Two or more people are required to install or remove the television.

Some wall mounts (wall-hanging brackets) are not designed to be mounted to walls with steel studs or old cinder block constructions.

Ask your dealer or licensed contractor to properly secure the wall-hanging bracket.

Do not place the Plasma TV or its stand on a sloped or unstable surface.

The Plasma TV may fall or tip over.

Do not support the Plasma TV on a non-specified pedestal.

Do not place the Plasma TV on furniture that can easily be used as steps, such as a chest of drawers.

Do not climb or allow children to climb on the Plasma TV

Place or install the Plasma TV where it cannot be pushed, pulled over or knocked down.

Route all cords and cables such that they cannot be tripped over or pulled by curious children.

Do not place any objects on top of the Plasma TV.

If water spills onto the Plasma TV or foreign objects get inside it, a short-circuit may occur which could result in fire or electric shock. If any foreign objects get inside the Plasma TV, please consult an Authorized Service Center.

AC Power Supply Cord

To prevent fire or electric shock:

The Plasma TV is designed to operate on a 120 V AC, 60 Hz service. Insert the power cord plug as far as it will go into the wall socket.

If the plug is not fully inserted, heat may generate, which could cause a fire.

The included power cord is for use with this unit only.

Do not use any power cord other than that provided with this TV.

Do not handle the power cord plug with wet hands.

Do not do anything that might damage the power supply cord.

Ensure the earth pin on the power plug is securely connected to prevent electrical shock.

An apparatus with CLASS I construction shall be connected to a power socket outlet with a protective earthing connection.

Do not touch the power plug with a wet hand. (This may cause electrical shock.)

Do not use any power cord other than that provided with this TV. (This may cause fire or electrical shock.)

Do not damage the power cord. (A damaged cord may cause fire or electrical shock.)

Do not move the TV with the cord plugged in the socket outlet.

Do not place a heavy object on the cord or place the cord near a high-temperature object.

Do not twist the cord, bend it excessively, or stretch it.

Do not pull on the cord. Hold onto the power plug body when disconnecting cord.

Do not use a damaged power plug or socket outlet.

If Problems Occur During Use

If a problem occurs (such as no picture or no sound), or if smoke or an abnormal odor is detected from the Plasma TV, unplug the power supply cord immediately.

Continued use of the TV under these conditions might cause a fire or permanent damage to the TV. Have the TV evaluated by an Authorized Service Center. Servicing of the TV by unauthorized personnel is strongly discouraged due to its high voltage.

If water or an object get inside the Plasma TV, if the Plasma TV is dropped, or if the enclosure becomes damaged, unplug the power supply cord immediately.

A short-circuit may occur, which could cause a fire. Contact an Authorized Service Center for an evaluation.

CAUTION

Do not cover the ventilation holes.

Doing so may cause the Plasma TV to overheat, which can cause a fire or damage to the Plasma TV.

Leave a space of 3 15/16” (10 cm) or more at the top, left and right, and 2 3/4” (7 cm) or more at the rear.

When using the pedestal, keep the space between the bottom of the TV and the pedestal or stand surface clear from objects that may obstruct ventilation.

When Moving the Plasma TV

Be sure to disconnect all cables before moving the Plasma TV.

Moving the TV with its cables attached might damage the cables which, in turn, can cause fire or electric shock

To prevent an electric shock, disconnect the power plug from the wall outlet as a safety precaution before carrying out any cleaning.

5

Image 5
Contents Viera Guía de inicio rápidoSdhc Logo is a trademark Turn your own living room into a movie theaterHDMI, the Hdmi logo and High Contents Important Safety Instructions Safety PrecautionsSet up Handling the power supply cordAC Power Supply Cord If Problems Occur During UseThis may cause damage resulting in injury Transport only in upright positionComputer image Do not display a still picture for a long timeTypical still images Accessories Accessories/Optional AccessoryOptional Accessory AccessoriesBottom view Attaching the pedestal to TVDo not disassemble or modify the pedestal Do not use any other TV and displaysTo attach To remove AC cord connectionDown Insert it firmly until Tabs on both sides click Into placeBasic Connection Connecting Antenna To watch TVVHF/UHF Antenna Back of the TVConnecting DVD recorder VCR To record/playback QuickGuideStart Basic Connection Connecting DVD recorder VCR and satellite receiverSatellite DVD Recorder ReceiverVCR AV cable connectionsFront of the TV TV controls/indicatorsIdentifying Controls Turn the TV On with the Power button First Time SetupSelect your language Be sure to select HomeAuto channel setup Adjust the clockStart scanning the channels Set the Input labelsConfirm registered channels Press to exit from a menu screenWatching TV Turn power on Select a channel numberClosed Caption Display To watch TV and other functionsInformation Favorite FeatureRecall Change aspect ratio Call up Favorite channelSelect next Using Viera ToolsDisplay Viera Tools Select the item Viewing from an SD Card Set SD card setting and select Play SD card nowInsert the SD card Select the data to be viewedSD Card SettingsPhoto FromWatching Videos and DVDs Display the Input select menu Select the input modeInput Select To return to TVDisplay menu Select Viera Link settingsSelect Viera Link SelectSelect the menu How to Use Menu FunctionsAdjust or select Adjustments/Configurations alternatives Sub menu list Display Sub MenuSets the time for Pixel orbiter-Periodic setting /2/3/4 Adjusts the clock pSets Power on link of Hdmi connection equipment p Yes/No Sets Power off link of Hdmi connection equipment p Yes/NoHdmi cable Viera LinkTM Hdavi ControlTMViera LinkTM Connections Setting of this unit after connectionDigital Audio out Back of the TV Hdmi cableSet Select settingsSelect On For Recorder Transmittable data Recorder HomeDisplay Viera Link menu Viera Link control only with the TV s remote controlSpeaker control ChangeSelect Speaker output Select Home theater or TV Available TV s remote control buttonsSAP Select Audio Mode Lock Input your 4-digit passwordSelect the Lock mode Program lock Change passwordChannel lock Game lock Select ANT/Cable setup Editing and Setting ChannelsCheck signal strength Set automaticallyTo cancel the Edit Select a scanning mode pSelect Edit Select the item to be edited EditDisplay Closed Caption Closed CaptionDisplay menu Select Closed Caption Select Connected devices Input LabelsSelect Input labels Display labels of Connected devicesSelect the timer to set Using TimerSet the timer To set Sleep Off TimerOptical digital audio cable Recommended AV ConnectionsAmplifier Connect with Or BRatings List for Lock Aspect Ratio Format Technical InformationClosed Caption CC SD Card warning messages Meaning Data format for SD Card browsingMessage Viera LinkTM Hdavi ControlTM Picture modeHdmi connection Digital Audio OUT terminalsSize Input signals that can be displayedSide bars Scrolling barFirst unplug the Power cord plug from the wall outlet Care and CleaningDisplay panel CabinetIntermittent sound Interference or frozen digital channelsActions Screen Sound ProblemSpecifications Limited Warranty Limits And Exclusions Limited Warranty CoverageOn-Site or Carry-in Service Accessory Purchases United States and Puerto Rico Customer Services Directory United States and Puerto RicoPanasonic Product Limited Warranty Limited Warranty for CanadaPage Page Page Page Anotación del cliente Customer’s RecordPage Child Safety ~fA ~fA Page Business Reply Mail AN IlEARLY Birdii Discounti Name AddressApt Panasonic Panasonic Consumer Electronics Company Panasonic
Related manuals
Manual 60 pages 42.81 Kb