To freely change settings after Auto setup
Select the programme number and search through the channel
Store | Repeat |
When the desired | and |
Programme Channel number
10
Store | Programme down/up |
Return | Search down/up |
Exit |
Manual tuning
selectsearch programme
channel is found, | Note |
press OK to | |
store. | If a VCR is |
| •connected with |
OK | only the RF |
The programme | cable, select |
programme | |
•number blinks. | number "0". |
For Manual tuning, using the buttons on the unit
("Tuning mode" on p. 7)
STR | F | / | TV/AV |
|
|
|
|
F | (Press until "Tuning mode" appears) | ||
| or | / | (Access Tuning menu) |
|
|
| |
F | (Press until "Manual tuning" is reached) | ||
| or | / | (Access Manual tuning) |
|
|
| |
TV/AV | (Programme, Channel (select), Sound system) | ||
| or / | (Change programme or start searching | |
channels) |
| ||
STR | (Store) |
| |
- | (Repeat) | ||
| ■To return to TV | ||||
| F |
|
|
|
|
Programme number | 10 |
|
|
|
|
(Blinks) | 4. 5MHz |
| : Search |
|
|
|
|
| |||
| Manual tuning |
|
|
|
|
| TV / AV |
| : Move cursor |
| |
| STR |
| : To store |
|
|
| F |
| : To exit |
|
|
Sound system | STR | F | + / | TV / AV | |
|
|
|
|
| |
(Blinks) | Channel |
|
|
|
|
|
|
|
|
| |
•Editing and Setting Channels
Allows you to change the sound system used for a programme channel.
(4.5MHz / 5.5MHz / 6.0MHz / 6.5MHz)
Select the channel you want to adjust Set this function | OK |
Lets you select the correct transmission standard for the transmission signal being received. (p. 15)
(Auto / PAL / SECAM / NTSC 4.43 / NTSC 3.58)
Select the channel you want to adjust Set this function | OK |
•Normally, select "Auto" |
|
For the small adjustments to the tuning of an individual channel (useful for example when weather conditions are affecting reception quality of a programme)
Select the channel you want to adjust Set this function | OK |
|
•To cancel Fine tuning, tune again by Manual tuning |
|
|
For skipping the programme numbers on which no TV stations are tuned |
| |
Select the programme numbers you want to skip Set "Skip" to "On" | OK | |
To skip another channel, select the channel number via channel number buttons (if selecting two digits channel,
•If you intend to change the skip settings for a number of channels, write the channels’ numbers on a piece of paper before you begin.you must first press the
Advanced
17