Panasonic TX-32F500A Helpful Hint Normalization, Colour temperature, Scan mode, Mode Function

TX32F500A-2912_E Page 18 Monday, July 18, 2005 6:05 PM

Picture Menu

Colour temperature	AIlows you to set the overall colour tone of the picture.
	Press	or		to switch between modes
			Standard		Warm	Cool

P i c t u re menu Menu

Con t r as t Br i gh t nes s Co l ou r

Sha r pness

Co l ou r t empe r a ture

P NR

Sc an mode

Cinema

Standard Auto 75/833i

P-NR	Automatically reduces unwanted picture noise.
(Picture Noise Reduction)	Press	or	to switch between modes
				Off	Strong
				Auto	Weak

P i c t u re menu Menu

Con t ras t Br i gh t nes s Co l ou r Sha r pness

Co l ou r t empe r a ture P–NR

Sc an mode

Dynamic

Warm Weak 75/833i

Scan mode	Lets you choose the screen refresh method:
	Press	or	to switch between modes

75/833i 100Hz Progressive

P i c t u re menu Menu

Con t ras t Br i gh t nes s Co l ou r Sha r pness

Co l ou r t empe r a ture P–NR

Sc an mode

Dynamic

Warm Weak 75/833i

MODE	FUNCTION
75/833i	The 75/833i mode gives a faster refresh rate and more lines
	than a standard television.
100Hz	100Hz will give a steady picture for most signal
	transmission.
Progressive	Recommended when receiving NTSC signals.

100Hz/

Switching is also possible using PROGRE on the Remote Control to change the Picture

refresh setting between 75/833i, 100Hz and Progressive (for PAL signal).

Note:

•When viewing a PAL transmission (other than PAL 60) with Scan mode set to Progressive, the screen will flicker, this is not a fault.

Helpful Hint (

N

Normalization)

By pressing the Normal “N” button on the Remote Control while the Picture menu is displayed, the selected menu will be changed to the Normal Mode.

Normalization will not occur if the menu is not displayed when the “N” button is pressed.

The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.

18