Panasonic TQB2AA0632E1 Input signal that can be displayed, PC Input Terminals Connection

Input signal that can be displayed

* Mark: Applicable input signal for Component (Y, PB, PR), HDMI and PC

			horizontal frequency (kHz)	vertical frequency (Hz)	COMPONENT	HDMI	PC
525	(480) / 60i		15.73	59.94	*	*
525	(480) /60p		31.47	59.94	*	*
750	(720) /60p		45.00	59.94	*	*
1,125		(1,080) /60i	33.75	59.94	*	*
1,125		(1,080)/60p	67.43	59.94		*
1,125		(1,080)/60p	67.50	60.00		*
1,125(1,080)/24p			26.97	23.98		*
1,125(1,080)/24p			27.00	24.00		*
640	× 400 @70		31.47	70.08			*
640	× 480 @60		31.47	59.94			*
Macintosh13” (640 × 480)			35.00	66.67			*
640	× 480 @75		37.50	75.00			*
852	× 480 @60		31.44	59.89			*
800	× 600 @60		37.88	60.32			*
800	× 600 @75		46.88	75.00			*
800	× 600 @85		53.67	85.08			*
Macintosh16” (832 × 624)			49.73	74.55			*
1,024		× 768 @60	48.36	60.00			*
1,024		× 768 @70	56.48	70.07			*
1,024		× 768 @75	60.02	75.03			*
1,024		× 768 @85	68.68	85.00			*
Macintosh 21” (1,152 × 870)			68.68	75.06			*
1,280		× 768 @60	47.78	59.87			*
1,280		× 1,024 @60	63.98	60.02			*
1,366		× 768 @60	48.39	60.04			*

Note

Signals other than above may not be displayed properly.

The above signals are reformatted for optimal viewing on your display.

PC Input Terminals Connection

Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)

Some PC models cannot be connected to the set.

There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal. The maximum resolution: 1,280 × 1,024

If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. Signal Names for D-sub 15P Connector

				Pin No.	Signal Name	Pin No.	Signal Name	Pin No.	Signal Name
11	12	13	14	15	R		GND (Ground)		NC (not connected)
6	7	8	9 10		G		GND (Ground)		NC
1	2	3	4	5	B		GND (Ground)		HD/SYNC
					NC (not connected)		NC (not connected)		VD
Pin Layout for PC Input Terminal					GND (Ground)		GND (Ground)		NC

Technical Information Support

Information

31