Panasonic TC-P60GT50, TC-P50GT50 Attaching the pedestal to TV, Removing the pedestal from the TV

Page 9

Assembling the pedestal

Attaching the pedestal to TV

 

 

 

Insert the protrusion of the Neck

Turn the stand over and fix stand neck

 

into the Base firmly.

securely with assembly screws.

 

 

(for 50”: 3 screws, for 55”/60”/65”: 4 screws)

 

• Do not hold the neck when turning over the stand.

Neck

B x 3 pcs. (for 50”)

 

B x 4 pcs. (for 55”/60”/65”)

 

Protrusion of the

 

[TC-P50GT50]

 

Neck (bottom)

 

 

 

 

 

Hole for

Front

Front

screw

 

 

 

Back of Stand

 

 

[TC-P55GT50, TC-P60GT50,

 

TC-P65GT50]

 

Accessories

Assembly screws

A

XYN4+F10FNK (Black) size (M4 x 10)

(for 50” (5), for 55”/60”/65” (1))

B

XYN5+F16FN (silver)

size (M5 x 16)

(for 50” (7), for 55”/60”/65” (12))

Bracket (1)

TBL5ZA3254 (for 50”)

TBL5ZA3200 (for 55”/60”/65”)

Attach the Bracket to the protrusion of Neck. Make sure that the bracket is anchored before fixing the screws.

Fix securely with assembly screws. (4 screws)

Protrusion of Neck (top)

B x 4 pcs.

Bracket

Attach the cover and fix securely with assembly screw.

A x 1 pcs.

Cover

Neck (1)

TXFBL5Z0083 (for 50”)

TXFBL5Z0086 (for 55”/60”/65”)

Cover (1)

TXFBL5Z0091 (for 50”)

TXFBL5Z0056 (for 55”/60”/65”)

Set-up

Tighten assembly screws (for 50”)/ (for 55”/60”/65”) (total 4 screws) loosely at first, then tighten them firmly to fix securely.

Rear side

Cover is in the same bag with Owner’s Manual

Base (1)

TBL5ZX0313 (for 50”)

TBL5ZX0328 (for 55”)

TBL5ZX0379 (for 60”) TBL5ZX0381 (for 65”)

Arrow

markHole for pedestal installation

A x 4 pcs. (for 50”)

Bx 4 pcs. (for 55”/60”/65”) Bracket

Base

(Image) Work on a flat surface

Removing the pedestal from the TV

Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.

Remove the assembly screws (for 50”)/ (for 55”/60”/65”) from the TV.

Lift the TV from the pedestal.

Remove the assembly screw from the cover.

Pull out the cover.

Remove the assembly screws from the Bracket.

Remove the assembly screws from the Back of stand and pull out the neck.

Warning

Do not disassemble or modify the pedestal.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Caution

Do not use any pedestal other than that provided with this TV.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Do not use the pedestal if it becomes warped or physically damaged.

If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.

 

During set-up, make sure that all screws are securely tightened.

 

If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong

 

enough to support the TV, and it might fall over and become damaged, and personal injury may result.

 

When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above)

9

Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.

 

Image 9
Contents 49.9/55.1/60.1/64.7 inches measured diagonally English Español49,9/55,1/60,1/64,7 pulgadas medidas diagonalmente VieraDo not display a still picture for a long time Set upContents Important Safety Instructions Safety PrecautionsHandling the power supply cord AC Power Supply CordWhen Moving the Plasma TV Radio wavesAccidental Ingestion DisassemblyPlace 3D EyewearAbout built-in wireless LAN/Bluetooth Check that the Access point supports WPS*2FCC and IC Statement Accessories Communication CameraWall-hanging bracket Attaching the pedestal to TV Removing the pedestal from the TVDo not disassemble or modify the pedestal Installing the remote’s batteries Power cord connectionLocation To attach To removeConnections Connection PanelsAntenna or Cable connection Input select AV cable connectionAudio connection PC / Computer connection VGACable Binding Instructions Remote control TV controls/indicatorsIdentifying Controls Front of the TVPress Menu --Setup --Advanced setup --Auto power on First Time SetupSimply switches 3D ⇔ 2D images Auto mode Precautions for Viewing 3D ImagesViewing 3D images on TV Viewing 3D imagesDisplay eHELP Using eHELP Built-in ManualCare and Cleaning Others SpecificationsStandard Compliance Access ModeFrequency Range *1,*2 SecurityLimited Warranty Coverage On-Site or Carry-in ServiceLimited Warranty Limits And Exclusions Accessory Purchases United States and Puerto Rico Customer Services Directory United States and Puerto RicoFor hearing or speech impaired TTY users, TTY Panasonic National Parts CenterPanasonic Product Limited Warranty Limited Warranty for CanadaTC-P50GT50 TC-P55GT50 TC-P60GT50 TC-P65GT50 Customer’s Record Anotación del clienteAmbler Drive
Related manuals
Manual 26 pages 12.49 Kb