Panasonic TC-P50GT50 and TC-P55GT50 Flat Panel Television Assembly Manual

■Assembling the pedestal

Insert the protrusion of the Neck into the Base firmly.

Attaching the pedestal to TV

Turn the stand over and fix stand neck securely with assembly screws.

(for 50”: 3 screws, for 55”: 4 screws)

•Do not hold the neck when turning over the stand.

Accessories

Assembly screws

Neck

Protrusion of the

Neck (bottom)

Front

Back of Stand

Bx 3 pcs. (for 50”) B x 4 pcs. (for 55”)

[TC-P50GT50]

Hole for screw

XYN4+F10FNK (Black) size (M4 x 10)

(for 50” (5), for 55” (1))

XYN5+F16FN (silver)

size (M5 x 16)

(for 50” (7), for 55” (12))

Bracket (1) TBL5ZA3254 (for 50”)

[TC-P55GT50]

TBL5ZA3200 (for 55”)

Attach the Bracket to the protrusion of Neck. Make sure that the bracket is anchored before fixing the screws.

Fix securely with assembly screws. (4 screws)

Protrusion of Neck (top)

B x 4 pcs.

Bracket

Attach the cover and fix securely with assembly screw.

A x 1 pcs.

Cover

Neck (1)

TXFBL5Z0083 (for 50”)

TXFBL5Z0086 (for 55”)

Cover (1)

TXFBL5Z0091 (for 50”)

■Set-up

Tighten assembly screws (total 4 screws) loosely at first, then tighten them firmly to fix securely.

Rear side

TXFBL5Z0056 (for 55”)

Cover is in the same bag with Owner’s Manual

Base (1)

TBL5ZX0313 (for 50”) TBL5ZX0328 (for 55”)

Arrow mark

Hole for pedestal installation

A	x 4 pcs. (for 50”)
B	x 4 pcs. (for 55”)

Bracket

Base

(Image) Work on a flat surface

Warning

Removing the pedestal from the TV

Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.

Remove the assembly screws (for 50”)/ (for 55”) from the TV.

Lift the TV from the pedestal.

Remove the assembly screw from the cover.

Pull out the cover.

Remove the assembly screws from the Bracket. Remove the assembly screws from the Back of stand and pull out the neck.

Do not disassemble or modify the pedestal.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Caution

Do not use any pedestal other than that provided with this TV.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Do not use the pedestal if it becomes warped or physically damaged.

If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above)
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.	9
	9