Panasonic TH-L32C30X Problem Actions, Chaotic image, noisy, Check applicable data format. p

d

s

Problem Actions

●Change the setting of [P-NR] in the Picture Menu (to remove noise).

Chaotic image, noisy (p. 24)

●Check nearby electrical products (car, motorcycle, fluorescent lamp).

	No image can be	●Is [Colour] or [Contrast] in the Picture Menu set to the minimum?
Screen	displayed	(p. 24)
	Blurry or distorted
	image	●Reset channels (p. 31)
	(no sound or low
	volume)
	Unusual image is	●Turn the TV Off with Mains power On / Off switch, then turn it On
	displayed	again.
Sound	No sound is produced	●Is “Sound Mute” active? (p. 11)
		●Is the volume set to the minimum?
	Sound level is low or	●Sound signal reception may be deteriorated.
	sound is distorted	●Set [MPX] in the Sound Menu to [Mono]	(p. 27)
		●Set the sound setting of the connected equipment to “2ch L.PCM”.
	Sound is unusual	●Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu. (p. 27)
		●If digital sound connection has a problem, select analogue sound
HDMI		connection. (p. 62)
	Pictures from external	●Check that the HDMI cable is connected properly. (p. 53, 58 - 60)
	equipment are unusual	●Turn the TV and equipment Off, then turn them On again.
	when the equipment is	●Check the input signal from the equipment.	(p. 63)
	connected via HDMI	●Use an equipment compliant with EIA/CEA-861/861B.

●Check that the LAN cable or Wireless LAN Adaptor is connected properly. (p. 45)

	Cannot connect to the	●Check the connections and settings.	(p. 46 - 48)
	network	●Check the network equipment and network environment.
Network	file during DLNA	●If the problem persists, consult your Internet Service Provider or		Questions
		●Check applicable data format. (p. 65 - 66)
		telecommunications company.
	Cannot select the	●Is media server prepared? (p. 44)
	operations			Asked
	Cannot access the	●Check the connections and settings.	(p. 46 - 48)
	Internet contents	●The server or connection line might be busy now.		Frequently
	The TV goes into	●Auto power standby function is activated.
		●The TV enters Standby mode about 30 minutes after analogue
	Standby mode
		broadcasting ends.
Other
		●Are the batteries installed correctly?	(p. 8)
	The remote control	●Has the TV been switched On?
		●Point the remote control directly at the front of the TV
	does not work or is
		(within about 7 m and a 30 degree angle from the front of the TV).
	intermittent
		●Place the TV away from sunshine and do not let other sources of
		bright light to shine on the TV’s remote control signal receiver.

69

TH_L32C30KMTX_EN.indd 69

3/18/2011 4:26:30 PM