FAQs
Problem | Actions |
●Change the setting of
Chaotic image, noisy●noise). (p. 20)
Check nearby electrical products (car, motorcycle, fluorescent lamp).
Screen
Sound
HDMI
Other
No image can be displayed | ●Is “Colour” or “Contrast” in the Picture Menu set to the minimum? | |
(p. 20) | ||
| ||
|
| |
Blurry or distorted image | ●Reset channel. (p. 27) | |
(no sound or low volume) |
| |
|
| |
Unusual image is displayed | ●Turn off the TV with Mains power On / Off switch, then turn it on | |
again. | ||
| ||
|
| |
No sound is produced | ●Is “Sound Mute” active? (p. 8) | |
●Is the volume set to the minimum? | ||
|
| |
Sound level is low | ●Sound signal reception may be deteriorated. | |
or sound is distorted | ●Set “MPX” (p. 20) in the Sound Menu to “Mono”. | |
|
| |
| ●Set the sound setting of the connected equipment to “2ch L.PCM”. | |
Sound is unusual | ●Check the “HDMI1 / 4 Input” setting in the Sound Menu. (p. 20) | |
●If digital sound connection has a problem, select analogue sound | ||
| connection. (p. 32, 43) | |
Pictures from external equipment | ●Is the HDMI cable connected properly? (p. 43) | |
●Turn Off the TV and equipment, then turn them On again. | ||
are unusual when the equipment | ||
●Check an input signal from the equipment. (p. 44) | ||
is connected via HDMI | ●Use an equipment compliant with | |
TV goes into “Standby mode” | ●Off Timer function is activated. | |
●The TV enters “Standby mode” about 30 mins. after analogue | ||
| broadcasting ends. | |
|
| |
The remote control does not | ●Are the batteries installed correctly? (p. 6) | |
work | ●Has the TV been switched On? | |
|
|
46