Panasonic TH-42PZ800A, TH-50PZ800A Attaching the pedestal, Adjust the panel to your desired angle

Attaching the pedestal

Warning

Do not disassemble or modify the pedestal.

•Otherwise the TV may fall over and become damaged, and personal injury may result.

Caution

Do not use any other TV and displays.

•Otherwise the TV may fall over and become damaged, and personal injury may result.

Do not use the pedestal if it becomes warped or physically damaged.

•If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic dealer immediately.

During set-up, make sure that all screws are securely tightened.

•If insuffi cient care is taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV, and it might

fall over and become damaged, and personal injury may result.

Ensure that the TV does not fall over.

•If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury may result.

Two or more people are required to install and remove the TV.

•If two or more people are not present, the TV may be dropped, and personal injury may result.

Assembly screw (4)	Assembly screw (4)
(silver)	(black)
•XYN5+F18FN	•THEL060N
M5 × 18 mm	M5 × 25 mm
Pole (2)	Base
L:TBLA3615	TBLX0047-1
•R:TBLA3614	•(TH-42PZ800A)
	TBLX0048-1
	•(THTH--50PZ800A46PZ800A)

LR

ŶSecuring the TV

Use the assembly screws to fasten securely.

•Make sure that the screws are securely tightened.

•Carrysurface.out the work on a horizontal and level

View from the bottom

BM5 × 25 mm

Arrow mark

Hole for pedestal installation

D

Adjust the panel to your desired angle

•Ensure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range.

•Do not place any objects or hands within the full rotation range.

Quick Start Guide •Accessories / Options

ŶAssembling the pedestal

Use the four assembly screws to fasten the left and right poles to the base securely.

•Make sure that the screws are securely tightened.

•Forcing the assembly screws the wrong way will strip the threads.

•“L”pole.or “R” mark is stamped on the bottom of the

A M5 × 18 mm

Set the mark at the centre as illustrated, to have the swivel positioned at the centre of the rotation angle.

b

c c

R

	a
	(View from the top)
D	TH-42PZ800A
L	•a: 521 mm / b: 425 mm / c: 15°
Front
	TH-46PZ800A, TH-50PZ800A
	•a: 513 mm / b: 453 mm / c: 10°

7