Example of Network Connection Wired LAN

Connections

Example of Network Connection (Wired LAN)

COMPUTER	Display (main unit, rear)
	Less
	than
	3.9 inch
	(10 cm)
LAN cable
(not supplied)	Ferrite core
	(supplied)

	Installing the Ferrite core
Ferrite core	Less	Open
(supplied)	than	Open
	3.9 inch (10 cm)
	Pull back the tabs	Wind the cable	Press the cable
	(in two places)	twice	through and close

Hub or broadband router

Notes:

•Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.

•To connect a device using 100BASE-TX, use “category 5” LAN cable.

•Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge. Do not touch the LAN terminal or a metal part of the LAN cable.

•For instructions on how to connect, consult your network administrator.

Connecting Wireless Module (Wireless LAN)

To use the wireless function, the wireless module (ET-WM200U) (sold separately) is necessary.

When connecting the wireless module to the display, remove the protective ﬁlm and cap.

Connecting procedure

Hold the wireless module with its LED on the near side and connect it to the wireless module connection terminal.

(8Ω,20W[10W+10W])

Note:

Do not connect any other device than the wireless module (ET-WM200U).

When using the electronic pen

Using the electronic pen with the wireless module (ET-WM200U) connected may result in malfunction of the electronic pen due to radio wave interference as an example. In that case, set “WIRELESS LAN” to “OFF” before using the electronic pen. (refer to “Operating Instructions, Network Operations”)

ET-WM200

LED