Panasonic TC-29G12P service manual Remote Control Transmitter, Inserting batteries

Page 16

- 16 -

Remote Control Transmitter

Inserting batteries

1.Open the cover of the battery compartment, located on the back of the remote control unit.

2.Insert the batteries in the compartment, paying attention to correct polarities, as shown in the illustration.

3.Close the battery compartment, sliding the cover in place.

Useful Suggestions:

Replace batteries when noticing any failure in the functioning of the remote control unit.

If the remote control is frequently used, we recommend the use of alkaline batteries, with longer life.damage the unit.

Precautions when using batteries

The incorrect insertion of batteries in the compartment can cause leaking and corrosion of metal parts, and may Observe the following precautions:

1.Batteries should be replaced in pairs.

2.Do not mix new and used batteries.

3.Do not mix different types of batteries (for example, carbon-zinc with alkaline batteries).

4.Do not attempt to charge, short-circuit, open, warm up or burn used batteries.

5.Remove the batteries from the unit, if the unit is not going to be used for a long while.

COVER

PUSH AND

PULL TO

OPEN THE

COVER OF

THE BATTERY

COMPARTMENT

POLARITY

Operation Guide

TC-20G12P / TC-29G12P

Note:

Once discharged, the batteries included with this product may be disposed off with domestic trash.

/ TC-29G12PU

Image 16

Contents Remote Control Transmiter Provided accessoriesTelevisor TC-20G12P TC-29G12P TC-29G12PUImportant Safety Notice Table of ContentsRemote control Operation GuideFrontal View Rear viewHow to connect an external antenna TC-20G12P / TC-29G12POperation Selection of audio mode STEREO, SAP, Mono and Sound AI Selecting the Menu languageOperation Operation Guide Game GuardProgramming timer ON/OFF Automatic turning off Sleep TimerSetting Characteristic Operation Antenna mode Automatic channel tuningManual channel tuning Auto Power onSubtitles display mode cc Mode Channel captionConnecting to an amplifier stereo equipment Connecting to a videocassette recorder VCROperation GuideRemote Control Transmitter Inserting batteriesService Adjustments and Calibrations PowerInitial Data Recording in the Memory Eeprom Data Memory on the ScreenDeflection Circuit PRE-ADJUSTEMENTS AGC Circuit PRE-ADJUSTMENTSWhite Balance Adjustments Electrical InspectionsAFT Adjustments RF AGC Adjustment If Detector Output AdjustmentSUB-CONTRAST Adjustment +B Voltage VerificationNtsc SUB-TINT Adjustment PAL SUB-COLOR AdjustmentSUB-BRIGH PRE-ADJUSTMENT MTS Circuit Adjustment Audio Outpup Level VerificationSynthetizer Adjustments Deflection Circuit AdjustmentHUM Verification Audio Output Check UPCRT CUT OFF Adjustment White Balance AdjustmentSUB Bright Adjustment Focus AdjustmentColor Killer Verification Filament Voltage Check UPDynamic Convergence Adjustment Purity and Convergence AdjustmentsVerify Purity Adjustment with the Help of a Microscope Standard DAC table TC-20G12P / TC-29G12P / TC-29G12PU Waveforms IC001 Pins and Functions SyncIC601 Block Diagram IC601 Pins and FunctionsBoard Components side Top view Board Foil side Bottom view Cabinet Parts Location Cabinet Replacement Parts List TC-20G12P TC-29G12P TC-29G12PUReplacement Parts List CapacitorsDiodes Transistors ERDS2TJ181T Transformers Especial Replacement Parts Table Page CS Group Technical Support