Precautions, Description of Controls | Sylvania 6260VD specification

PRECAUTIONS

Install Location

For safety and optimum performance of your VCR:

•Install the VCR in a horizontal and stable position. Do not place anything directly on top of the VCR. Do not place the VCR directly on top of the TV.

•Shield it from direct sunlight and keep it away from sources of intense heat. Avoid dusty or humid places. Avoid places with insuffi- cient ventilation for proper heat dissipation. Do not block the ventila- tion holes on the sides of the VCR. Avoid locations subject to strong vibration or strong magnetic fields.

Avoid the Hazards of Electrical Shock and Fire

•Do not handle the power cord with wet hands.

•Do not pull on the power cord when disconnecting it from AC wall outlet. Grasp it by the plug.

Moisture Condensation Warning

Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place, or after heating a cold room or under conditions of high humidity. Do not use the VCR at least for 2 hours until its inside is dry.

FCC Warning

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful inter- ference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

Important Copyright Information

Unauthorized recording or use of broadcast television programming, video tape, film or other copyrighted material may violate applicable copyright laws. We assume no responsibility for the unauthorized duplication, use, or other acts which infringe upon the rights of copy- right owners.

A Note about Recycling

This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recy- cling regulations. Batteries should never be thrown away or incinerat- ed but disposed of in accordance with your local regulations concern- ing chemical wastes.

Note to the Cable TV System Installer

This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which pro- vides guidelines for proper grounding – in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION:

POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE COR- RESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

DESCRIPTION OF CONTROLS

Front Panel

Remote Control

1. EJECT button

	POWER	CHANNEL				MENU REC/OTR STOP/EJECT	REW	PLAY	F.FWD
VIDEO	L - AUDIO - R	POWER	VCR/TV	TAPE IN	TIMER	REC

13	12	11	10	9	8	7 6	5	4	3	2
1. Cassette Compartment						18. Display Window
2. F.FWD button						19. Remote Sensor				) buttons
3. PLAY button						10. CHANNEL (				) buttons
4. REW button						11. POWER button
5. STOP/EJECT button						12. AUDIO Input jacks
6. REC/OTR button						13. VIDEO Input jack
7. MENU button
Display Window

EJECT

1 2

MENU 0

RECORD SPEED

REW

STOP

POWER

VCR / TV

6 CHANNEL

9 -MODE

C.RESET

SLOW EXIT

PAUSE

DISPLAY /STILL

PLAY

F.FWD

172. NUMBER buttons

3. MENU button

164. RECORD button

5. SPEED button

156. REW button

7.STOP button

8.PLAY button

149. F.FWD button

1310. DISPLAY button

1211. PAUSE/STILL button

1112. SLOW button

1013. C.RESET/EXIT button

914. SEARCH-MODE button

15.CHANNEL () buttons

816. POWER button

17. VCR/TV button

POWER	VCR/TV	TAPE IN	TIMER	REC
POWER				REC
14	15	16	17	18
14. POWER indicator		17. TIMER indicator
15. VCR/TV indicator		18. REC indicator
16. TAPE IN indicator

To insert the batteries

Install two AA batteries

(supplied) matching the

polarity indicated on the

bottom of the remote

control.

Rear Panel

19.AUDIO OUT jacks

20.AUDIO IN jacks

21.ANT. IN jack

22.ANT. OUT jack

20 21

AUDIO		ANT
	L	IN
	L
OUT	IN
	R
VIDEO		OUT
OUT	IN

24 23 22

23.VIDEO IN jack

24.VIDEO OUT jack

25.AC Power Cord

VIDEO OUT Jack

Connect a video cable going to the video in jack of a camcorder, another VCR, a TV, or an audio- visual system (laser disc player, video disc player, etc.) here.

AUDIO OUT Jacks

Connect the audio cables going to the audio in jacks of a cam- corder, another VCR, a stereo amplifier, or an audio system here.

VIDEO IN Jack

Connect a video cable coming from the video out jack of a camcorder, another VCR, or an audio-visual source (laser disc player, video disc player, etc.) here.

AUDIO IN Jacks

Connect the audio cables com- ing from the audio out jacks of a camcorder, another VCR, or an audio source here.

– 2 –