ASA Electronics owner manual DV352 Wiring, Power Connections Audio/Video Connections

Page 5

DV352

Wiring

Power Connections

Audio/Video Connections

1.GROUND WIRE (black) – Securely fasten the Ground wire to a grounded metal part of the car’s chassis. If you cannot find an existing bolt or screw to fasten it to, drill a hole in the metal and secure it with a screw. To ensure a good ground, remove any paint or grease from areas where the wire will contact the surface.

2.CONSTANT POWER WIRE (yellow) – Connect the 12V PLUS constant power wire to a live 12 volt wire in the vehicle. Before making a connection, check that the wire you intend to connect it to is always live, even when the car’s ignition is turned off. If a live wire is not found, route the wire to the car’s fuse block and connect it to a live circuit there.

3.ACC POWER WIRE (red) – Connect to a +12 volt circuit that is only live when the ignition is on. The best connection point is at the car’s fuse block at the “RADIO” or “ACCESSORY” identified terminals.

VIDEO 1

AUDIO INPUT 1

AUDIO OUT

 

VIDEO

VIDEO

INPUT

L

R

L

R

OUT1

OUT2

DC12VIN DC12VOUT

 

 

+

 

 

 

 

 

 

 

 

 

REMOTE

 

 

 

 

VIDEO 1

AUDIO INPUT 1

AUDIO OUT

 

VIDEO

VIDEO

 

INPUT

L

R

L

R

OUT1

OUT2

DC12VIN

DC12VOUT

 

 

 

+

 

 

 

 

 

 

 

 

 

 

REMOTE

 

 

 

 

 

 

 

REMOTECONTROL RECEIVER

 

 

 

Black

Yellow

3A

Red

0.5A

+

1Ground

Connect to ground terminal.

2Memory/Battery

Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.

3Accessory/Ignition Connect to existing radio wire or radio fuse.

YELLOW

WHITE

RED

WHITE

RED

YELLOW

YELLOW

NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the DVD player. The DV352 uses one 3 amp and one 0.5 amp ACG fuse, located in the black filter boxes in-line with the power wires.

5

Image 5
Contents Thank You DV352Preparation DV352 IntroductionDIN Front-Mount Installation DV352 InstallationReconnecting the Battery DIN Rear-Mount InstallationDV352 Removing the UnitPower Connections Audio/Video Connections DV352 WiringRemote Control Operation DV352 Controls and IndicatorsUsing the Remote Control Front Panel OperationChanging the Battery Remote Control FunctionsDisc Operation DV352 Basic OperationRepeating Playback Pausing PlaybackPBC Play Back Control VCD Only ZoomingMenu Function Multi-Language Discs DVD OnlyTitle Menu Function Changing Audio LanguageGeneral Setup Setup MenuViewing an Alternate Picture Angle DVD Only Aspect RatioAudio Setup Disc Symbols and Properties Problem Cause Corrective Action TroubleshootingDay / 12 Month Limited Warranty DV352 SpecificationsLimited Warranty