Directed Video DV2600 manual DIN REAR-MOUNT Method B, Removing the Unit

Page 20

REMOVING THE UNIT

1

2

3

1.Trim ring.

2.Remove the trim ring by first detaching the face plate. Then using your fingers, press up and down at the top and bottom of the trim ring and pull out.

3.Insert the removal keys into the slots at either side of the unit until they click. Gently pull the unit sliding it out of the mount.

DIN REAR-MOUNT (METHOD B)

Install using the screw holes on the sides of the

unit.

1

2

4

35

2

5

To fasten the unit to the factory radio mounting bracket:

1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the screws at two places on each side. Use either truss screws (5x6mm) or flush surface screws (4x6mm) depending on the shape of the screw holes in the bracket.

2.Screw

3.Factory radio mounting bracket

4.Dashboard or console

5.Hook (Remove this part)

NOTE: The trim ring and half-sleeve are not used for method B installation.

20

© 2001 Directed Electronics, Inc.

Image 20
Contents DIN DVD Player Model DV2600Page Table of Contents Limited One-Year Warranty Safety Instructions Important SafeguardsUSE Authorized Service Centers For Installation Your WarrantyImportant Information Protect the Disc MechanismFeatures FeaturesAccessories Bit digital to analog converterHandling and Cleaning Disc CleaningDisc Notes Disc Formats Supported by this PlayerFront Panel Features Front Panel OperationTo Detach the Front Panel to RE-INSTALLTHE Front Panel Precautions When HandlingRemote Control Button DescriptionRemote Operation MULTI-AUDIO Function Menu FunctionSubtitle Language Function for DVD only MULTI-ANGLE Function for DVD onlyInitial Setup General SetupSetup --- Main Setup --- GeneralSetup General Setup Setup --- General SetupSpeaker Setup Preference Audio Language SetupSubtitle Language Setup PreferenceDisc Menu Language Setup PasswordDefault Settings General SET UP PreferenceInstallation Installing the UnitDIN FRONT-MOUNT Method a DIN FRONT/REAR-MOUNTDIN REAR-MOUNT Method B Removing the UnitWiring Guide Wiring ConnectionsPower wire Audio/video outputs for the amplifier and monitorSpecifications Supply voltageFrequency response 20 Hz-20 kHz Ratio 90 dB JISCompany behind this system is Directed Electronics, Inc